Mounting the Camera
●Use the screw hole on the camera mounting bracket to mount this camera to a fixer or rotating platform.
Mount the fall prevention wire using the black screw at the rear of the camera unit.
Camera
Mounting Camera Mounting
Screw Hole
Mounting the camera mounting bracket on the top of the camera
The camera mounting bracket is mounted on the bottom surface of the camera by default. To mount it to the top surface, do so by removing the two fastening screws from the camera mounting bracket. Make sure to fasten the screws firmly.
Camera
Mounting
Bracket Fastening Screw (2 pcs: M2.6 x 6 mm)
Bracket
Camera
Bracket
Fall
Prevention
Wire
M3x6 mm
(15/64 inch)
6 mm
2 mm and below
Note:
●When mounting the camera, use screws with a length between 5 mm to 7 mm from the mounting surface. Screws beyond the specified length may damage the interior, while those shorter than specified may cause the camera to fall off, and therefore these must not be used.
5 mm and above
7 mm and below
21