JVC VS-DT6, VS-DT8 1, 2, 3, 4, 5, 6

16

Using the Tuner

Presetting Stations

(Using the Remote Control)

You can preset up to 30 FM stations and up to 15 AM sta-

tions.

• Preset n umbers may have been set to factory test fre-

quencies prior to shipment. This is not a malfunction. You

can preset the stations you want into memory by following

one of the presetting methods below.

Manual Presetting

1Select a band by pressing the FM/AM

button.

2Press the 4 or ¢ ( or ) button to

tune in a station.

3Press the SET button.

“SET” will blink for 5 seconds.

Within 5 seconds, proceed to the next step.

When the display returns to the one set in step 2 after 5

seconds, press the SET button again.

4Press the > or < button within 5 seconds

to select the preset number.

> or < button: Increase or decrease the preset

number by 1.

Pressing and holding the button

will rapidly increase or decrease

the preset number.

5Press the SET button within 5 seconds.

“STORED” appears and after 2 seconds, the display re-

turns to the broadcast frequency display.

6Repeat above steps 1 to 5 for each sta-

tion you want to store in memory with a

preset number.

To change the preset stations, repeat the same

steps as above.

CAUTION:

•Even if the system is unplugged or if thepower failure occurs, the preset stationswill be stored for about 24 hours. However,in case the preset stations are erased, youwill need to preset the stations again.

To Change the FM Reception

Mode

(Using the Remote Control)

When you are tuned into an FM stereo broadcast, the

“STEREO” indicator lights up and you can hear stereo ef-

fects.

If an FM stereo broadcast is hard to receive or noisy, you

can select Monaural mode. Reception improves, but you

lose stereo effect.

Press the FM MODE button on the Remote Control

so that the “MONO” indicator lights up on the dis-

play.

To restore the stereo effect, press the FM MODE button

on the Remote Control so that the “MONO” indicator goes off.

SET STORED

SETSET

FM/AM

When changing the

Band FM = 30, AM = 15

or

MONO

FM MODE

VS-DT6-8(J)_EN.book Page 16 Monday, January 21, 2002 5:05 PM

Contents

Main COMPACT COMPONENT SYSTEM VS-DT6-8(J)_EN.book Page 1 Monday, January 21, 2002 5:05 PM For Customer Use: VS-DT6/VS-DT8 SP-VSDT8 SP-VSDT8 CA-VSDT8 Consists of CA-VSDT6 and SP-VSDT6 Consists of CA-VSDT8 and SP-VSDT8 CA-VSDT6 SP-VSDT6 SP-VSDT6 Warnings, Cautions and Others / Mises en garde, prcautions et indications diverses (For U.S.A) INFORMATION G-2 For Canada/pour le Canada For Canada/pour Le Canada CAUTION ATTENTION Introduction Features How This Manual Is Organized WARNINGS IMPORTANT CAUTIONS Table of Contents Getting Started Accessories How To Put Batteries In the Remote Control Handle batteries properly. Make all connections before plugging the System into an AC power outlet. Connecting the FM Antenna Rear Panel of the Center Unit Using the Supplied Wire Antenna Using the Coaxial Type Connector (Not Supplied) A 75 antenna with coaxial type connector should be con- nected to the FM 75 COAXIAL terminal. If reception is poor, connect the outdoor antenna. Connecting the AM Antenna Rear Panel of the Center Unit VS-DT6-8(J)_EN.book Page 5 Monday, January 21, 2002 5:05 PM AC IN Screw (not supplied) Turn the loop until you have the best reception. Connecting the Speakers Removing the speaker grilles When removing: When attaching the speaker grilles: Connecting a Subwoofer Connecting External Equipment Connecting an MD Recorder, etc (Digital Output) Connecting the AC Power Cord Installing the Unit on the Stand Installing the Equipment on the Wall Attachment to a wall Location of attachment to a wall Example of attachment (Center Unit) Changing the Display and Control Buttons Settings Set the DISP.SET switch to H. Set the DISP.SET switch to V. Example of attachment (Speakers) (SP-VSDT6 only) When the Unit is placed vertically Using the Remote Control COMPU Play On the Remote Control On the Unit Basic Operations Turning the Power On and Off Turning the System On Turning the System Off Adjusting the Brightness (DIMMER) When the System is Turned On 1 tem. 2 Control. 3 1 on the Remote Control. 2 on the Remote Control to adjust the bass level. TREBLE Control 1 on the Remote Control. 2 on the Remote Control to adjust the treble level. Showing the Time (DISPLAY) Using the Tuner One Touch Radio Tuning In a Station 1 2 1 2 tune in a station. 3 4 Using the CD Player To Insert a CD 1 2 label side front or up as shown below. 1 2 To Select a Track or Passage within a Track Search Play Programming the Playing Order of the Tracks 1 2 3 4 5 6 7 To Modify the Program 1 Remote Control until the RANDOM indicator lights. 2 Repeating Tracks Child Lock Using External Equipment Listening to External Equipment 1 2 Recording the Systems Source to External Equipment Using the Timers Setting the Clock 1 2 Remote Control. 3 1 2 3 4 5 6 the music source selected in step 3. 7 tem. Setting the SLEEP Timer Care And Maintenance Compact Discs General Notes Cleaning the unit Moisture Condensation Troubleshooting Page Page Specifications Amplifier 105.5 mm 140 mm 237 mm