JVC XV-N44SL CConnecting to a TV with component jacks

Preparations

Preparations

CConnecting to a TV with component jacks

You can enjoy picture of high-fidelity color reproduction by connecting the COMPONENT VIDEO OUT jacks on the unit to your TV.

NOTES

•Connect “Y” to “Y,” “PB” to “PB” (CB), “PR” to “PR” (CR) correctly.

•When using the COMPONENT VIDEO OUT jacks, do not connect the S-VIDEO output jack on the unit.

•When the component video input jacks on the TV is of the BNC type, use an adapter to convert a pin jack to a BNC jack (not supplied).

Progressive scan video playback available

In the Progressive scanning mode, you can enjoy high quality picture with less flickers when the COMPONENT VIDEO OUT jacks are connected to a TV or monitor that supports the progressive video input.

About the scanning mode

Depending on the material source format, DVD VIDEO discs can be classified into two types; film source and video source (note that some DVD VIDEO discs contain both film source and video source). Film sources are recorded as 24-frame-per- second information, while (NTSC) video sources are recorded as 30-frame-per-second (60-field-per-second interlaced) information.

When the unit plays back a film source material, uninterlaced progressive output signals are created using the original information. When a video source material is played back, the unit interleaves lines between the interlaced lines on each to create the interpolated picture and outputs as the progressive signal.

TV

The unit

IN

PR

Red

PB

Y

Bule

S-

VIDEO

EN

T

VIDEO

LEFT

White

AUD

IO

Green

RIGHT

Red

LINK

AV

COMPU

48

0p

OTE

REM

480i

SIGNAL

VIDEO

SELECTOR

EO

OU

T

VID

NEN

T

MPO

Red

CO

PB

UT

PR

Y

VIDEO

M/S

TREA

M

RIGHT

IO O

UT

White

S-

OUT

AUD

Green

VID

VIDEO

EO

Bule

Red

Audio cable (not supplied)

480p

480i REMOTE

VIDEO SIGNAL

SELECTOR

Component video cable (not supplied)

Selecting the VIDEO SIGNAL SELECTOR position

•If your television equipped with component jacks does not support the progressive scanning mode

Set the VIDEO SIGNAL SELECTOR to “480i.”

•If your television equipped with component jacks supports the progressive scanning mode

Set the VIDEO SIGNAL SELECTOR to “480p.”

•If you want to select the scanning mode between the interlace and progressive modes (depending on the source condition, or when connecting more than one television, etc.)

Set the VIDEO SIGNAL SELECTOR to “REMOTE.”

Thus you can select the mode from the remote control unit.

NOTE

You must change the VIDEO SIGNAL SELECTOR position while the unit power is off. Otherwise, the changed setting is not effective.

Activating the Progressive scan mode using the remote control unit

When the unit is turned on and the VIDEO SIGNAL SELECTOR is set to “REMOTE,” press and hold down VFP - PROGRESSIVE SCAN for a few seconds.

The scanning mode switches between the Progressive scanning and Interlaced scanning modes.

When the scanning mode is set to the Progressive mode, the PROGRESSIVE indicator on the front panel turns on. Depending on the [PICTURE SOURCE] setting on the [PICTURE] preference display and whether the current DVD VIDEO disc is film-source or video-source, the color of the indicator differs, as shown in the table below.

Setting of	Source type of DVD VIDEO
[PICTURE SOURCE]	Film source	Video source
AUTO	Green	Red
FILM	Green	Green
VIDEO (NORMAL)/	Red	Red
(ACTIVE)

*While stopped in the progressive scanning mode, the PROGRESSIVE indicator is lit in red regardless of the [PICTURE SOURCE] selection.

4