Stereo Audio System for Your iPod V10M10_IM_EN_10192006
www.i-Luv.com
- 7 -
GETTING STARTED
Installing the Remote Contr ol Battery
The remote control battery has been previously installed and ready for operation for immediate use. When the remote control
stops functioning, you must replace the battery with a new one. To do so, locate the battery compartment on the side of the
remote and follow the steps below:
1. Squeeze the notch labeled “Tab A” while pulling the “battery door latch B” out towards you. This will allow the battery
holder to release and pop out. Please refer to the picture on the right side.
2. Insert a “CR2025” 3V lithium battery. Make certain to follow the correct polarity, following the directions of the
corresponding symbols (+/-).
3. Secure battery and push the battery holder back into the remote control until fully inserted.
Installing the AM Loop Antenn a
For AM radio operation, locate the AM antenna jack on the back of the unit. Plug the AM loop antenna into the connector. To achieve the best reception
possible, a distance of 12” between the AM antenna, the unit and the iPod is recommended.
Installing the Dock Adapter
To guarantee that your iPod will fit properly into the built-in universal dock, several detachable dock adapters for old iPod players are included with this
product. Please check the bottom of dock adapters to determine compatibility with your iPod.
1. Inserting the dock adapter
a. Choose a dock adapter that corresponds with the iPod you would like to dock. Using the correct dock adapter ensures a proper fit.
b. Gently push the dock adapter down into the universal dock.
c. Carefully place your iPod into the universal dock. Please note that iPod must not be in a case or “Skin”.
2. Removing the dock adapter
a. Remove your iPod, grasp the dock adapter and lift upwards carefully.