Jwin JC-CD260 Removing the Front Panel, Installing the Front Panel, Din Front/Rear-Mount

REMOVING THE FRONT PANEL

Front Panel

1

6

7

1.Dashboard

2.Nut (5mm)

3.Spring washer

4.Screw (5 x 16mm)

5.Screw

6.Strap

Be sure to use the strap to secure the back of the unit of the place. The strap can be bent by hand to the desired

Release Button

2

5

angle.

7.Plain washer

INSTALLING THE FRONT PANEL

INSTALLATION

NOTE:

Choose the mounting location where the unit will not interfere with normal driving function. Before finally installing the unit, connect the wiring temporarily and make sure it is all connected properly and the unit and the system work properly.

Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.

3

1

3

1.Frame

2.Insert fingers into the groove in the front of frame and pull out to remove the frame .(When re-attaching the frame. Point the side with a groove downwards and attach it.)

3.Lever

Insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click.

Pulling the levers makes it possible to remove the unit from the dashboard.

Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.

Install the unit where it does not get in the driver s way and cannot injure the passenger if there is a sudden stop. Like an emergency stop.

If installation angle exceeds 30 from horizontal,the unit might not give its optimum performance. Avoid installating the unit where it would be subject to high temperature.such as from direct sunlight. Lower case or from hot air, from the heater,or where it would be subect to dust, dirt or excessive vibration.

4 SPEAKER WIRING

CONNECTIONS

DIN FRONT/REAR-MOUNT

This unit be can be properly installed either from Front (conventional DIN Front-mount) or Rear (DIN Rear-mount installation, utilizing threaded screw holes at the sides of the unit chassis). For detail, refer to the following illustrated installation methods.

DIN FRONT- MOUNT (Method A)

Installing the unit

1 2

1. Dashboard

2. Holder

After inserting the holder into the dashboard, select the appropriate tab according to the thickness of the dashboard material and bend them inwards to secure the holder in place.

3. Screw

3

ANTENNA

RED(R)

LINE OUT

WHITE(L)

RED(R)

LINE IN

WHITE(L)

FRONT

LEFT

SPEAKER

REAR

LEFT

SPEAKER

GRAY

BLACK

+WHITE

-WHITE/BLACK

+GREEN/BLACK

-GREEN

			BLACK
		FUSE	GROUND(-)
		0.5A	BLUE
			AUTO ANT(+)
		1A	RED
			B (+)
		7A	YELLOW
			BACK UP
	GRAY +		FRONT
			RIGHT
GRAY/BLACK-			SPEAKER
	VIOLET +		REAR
			RIGHT
VIOLET/BLACK-			SPEAKER

-- 6 -- -- 7 --