Jwin JL-CD808 manual P R E P A R A T I O N F O R U S E, L I S T E N I N G T O T H E R A D I O

P R E P A R A T I O N F O R U S E

Remove the stereo carefully from the box, retaining the packaging for future use.

Read these instructions carefully before use.

AC PO W E R OP E R A T I O N

Unravel the AC cord and connect it to a convenienty located AC outlet.

Press the STANDBY button to switch the unit on or off.

The Clock Display will show 12:00 and needs to be set.

If the AC cord is disconnected or if there is a power failure, the electronic clock is designed to continue operating internally (without showing the time on the Clock Display) with a 9 volt battery (not included). To install the battery, slide down the compartment cover at the back of unit) to open. Then, connect the battery to the terminals of the battery snap inside the compartment (use of an alkaline battery is recommended) and slide the battery compartment cover back into place.

AC O utlet

AC Plu g

9 V

Be sure to check the condition of the battery periodically by disconnecting the AC cord and connecting it again 2 or 3 minutes later. The preset times should continue operating. If the clock resets to ]12:00^ on the Clock Display, it indicates the battery is dead or not connected properly.

BATTERIES PR E C A U T I O N S

Follow these presautions when using batteries in this device:

1.Use only the size and type of batteries specified.

2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device.

3.If the device is not to be used for a long period of time, remove the batteries to prevent injury from possible battery leakage.

L I S T E N I N G T O T H E R A D I O

OPERATION

mPress the STANDBY/ON button to turn the unit on, the STANDBY/ON LED indicator will light.

mSilde the FUNCTION switch to the desired band (AM or FM) and tune a station by turning the TUNING control.

mWhen a strong FM stereo signal is received while listening to FM, the FM ST indicator will light and the sound will be heard in stereo.

mAdjust the VOLUME control as desired.

ANTENNA

For FM reception there is a built-in one-meter FM aerial wire at the rear of the unit. Unravel the wire and move it around to obtain the best reception. For MW reception the signals are picked up through the built-in ferrite antenna. You may have to move the unit to obtain the best reception.

2