130X93MM
KA2031
KA2031 is manufactured for
Electronics,Inc(USA) by Kaito Enterprises Corp. In Chinawww.kaitousa.com
PLL Digital Radio
With AM/FM/TV/NOAA Weather Bands
Buttons and Names
5 Never get the radio to a chemical that might damage the case of the radio.
SPECIFICATIONS24
23
22
21
20
19
1
AM/FM ST/TV/WB/NOAA PLL SYNTHESIZED STEREO WORLD RECEIVER
18
2 | 3 |
| 4 |
| 5 | 6 | Power Source | 3 AA size batteries(DC 4.5V) | |
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| Fre quencyRange | ||
|
|
|
|
|
|
| AM 520 - 1710 KHz | ||
|
|
|
|
|
|
| FM 88 - 108 M Hz | ||
|
|
|
|
|
|
| TV | ||
|
|
|
|
|
|
| WB | ||
|
|
|
|
|
| 7 | CHA NNE L FREQUENCY | ||
|
|
|
|
|
| 1 | 162.550 MHz | ||
|
|
|
|
|
| 8 | |||
|
|
|
|
|
| 2 | 162.400 MHz | ||
|
|
|
| SNOOZE |
| 9 | |||
|
|
|
|
|
| 3 | 162.475 MHz | ||
1/ALL1 SET | 2/ALL12 SET |
|
|
| 10 | ||||
|
|
|
|
|
| 4 | 162.425 MHz | ||
|
|
|
|
|
|
| |||
|
| BAND/ALERT | ENTER |
| 11 | 5 | 162.450 MHz | ||
25 | 26 |
|
|
|
| 12 | 6 | 162.500 MHz | |
16 | 15 | 14 | 13 | 7 | 162.525 MHz | ||||
| 17 |
| |||||||
|
|
|
|
|
|
| Speaker 8Ohms 1 W | ||
|
|
|
|
|
|
| Power Output | 200 mW |
1.Telescopic Antenna
2.Back Light Button
3.LCD
4.Stand (On the back side)
5.Power Button
6.Carrying Strap Holder
7.STAND BY/SLEEP
8.Tuning UP/MIN Set
9.Volume Control Knob 10.Tuning DN./HOUR set
11.Lock Switch 12.Preset 0......9
13.Snooze Button
14.Enter Button
15.BAND Selector
16.Mode Button
17.TIME SET/MEMORY
18.Reset (Inside battery compartment) 19.Battery Compartment
20.DC Jack 21.Earphone Jack 22.DX/Local Switch
23.Extend Antenna Jack
24.Volume Indicator
25.1/AL Set ( Alarm Set 1)
26.2/AL Set ( Alarm Set 2)
Output Jack Earphone 32 Ohm
Disclaimer:
Due to the signal strength changes in different areas in the country, the radio is not guaranteed to receive the NOAA alert signals, Kaito Electronics Inc. is not responsible for any damage or loss due to the NOAA signal is not received.
For any further information, please visit our website www.kaitousa.com Or contact us at toll free number
Kaito Electronics,Inc
5185 Cliffwood Drive, Montclair CA 91763 USA
1 | 6 |
|
The radio can be turned on at two different time.
1.When the radio is turned off, press 1/AL1 SET button twice, the " " will be shown on the LCD display, then press TIME SET MEMORY button twice, the " AL1 " will be shown and you can press HOUR/TUNE- and MIN/TUNE+ seperately to adjust the time. After the time flash several times, the radio wil display " " and clock. The radio will be turned on at the preset time. Press1/AL1 SET button, the function is cancelled.
2.When the radio is turned off, press 2/AL2 SET button twice, twice the " " will be shown on the display, then press TIME SET MEMORY button three times, the "AL2" will be shown and you can press HOUR/TUNE- and MIN/TUNE+ seperately to adjust the time. After the time flash several times,the radio wil display " " and clock. The radio will be turned on at the preset time. Press 2/AL2 SET button, the function is cancelled.
Note: Make sure you select AM/PM Properly.ANTENNAS
FM/TV/WB
Pull out the telescopic antenna and adjust its length and angle for optimum reception.
FM/TV/WB
AM
The built in ferrite antenna will give you a good reception on AM, but you need to adjust the direction to get the max reception on the AM station.
AM
RADIO MAINTENANCE1.If the radio is not used for a long time, remove the batteries from the battery compartment to prevent possible battery leakage.
2.The radio should be kept in a place with no extreme heat or cold. Do not get the radio in a very humidity place and never get any liquid into the radio.
3.Take the radio with care, any shock may damage the parts inside.
4.When use the radio in a moving vehicle , a cement building , use the radio close to the open window for better reception. Any metal will have interference on the reception.
5
BATTERY OPERATION
1.Open the battery compartment cover.
2.Insert 3 AA size batteries into the compartment, make sure the polarity is correct as shown on the diagram("+" and
1.Load the batteries with correct polarity.
2.If the radio is not used for a long time, remove all the batteries out and put it in a safe place. Avoid extreme hot or cold.
3.Remove the low batteries as soon as the sound volume gets low or hard to receive stations.
4.Do not mix the new and low batteries when you put the batteries in.
TO USE THE AC ADAPTOR (Optional)If you try use the AC adaptor, make sure the voltage and output polarity is correct as specified in the radio.
RADIO OPERATION1.Set LOCK switch to OFF.
2.Press POWER button to turn on the radio. 3.Adjust the volume to a proper level.
4.Use BAND/ALERT ( Band Selector15) to change bands between AM/FM/TV/WB.
5.Press the Light button, the backlight will last for 8 seconds. 6.To tune the radio, you can key in or step search for the AM/FM stations; for TV and Weather bands. On AM/FM bands, you can use the tuning button or numbers to direct key in the frequency; in TV/WB band, just press the tunning button to select the channels.
2
1. SETTING CLOCK MODE
When the radio is off, the current time displays on the LCD. When the radio is on, press MODE button, it switches among the modes: time, alert1, alert2, frequency and time repeatedly. If it is set to time mode, 4 seconds later, it will go back to frequency mode automatically.
2. ADJUSTING THE CLOCK
When the radio is OFF, press TIME SET button, the clock number will flash, then use the HOUR/TUNE+ button to adjust Hour, and MIN/TUNE- button to adjust minute. After a few seconds, the time is set automatically.
SLEEP TIMER1. When the radio is turned on, press the SLEEP button, then
90 and " SLEEP " will appear on LCD. You can select the desired time from 10 to 90 by pressing the SLEEP button, and the radio will turn off automatically at the preset time. If the knob is pressed again, the sleep function is cancelled.
TO SET THE ALARM TIMEYOU CAN SET TWO ALARM TIME
1.Turn off the radio;
2.Press 1/AL1 SET button, " 1 " will appear on the display. Then press TIME SET MEMORY button twice, " Al1 " will appear on the display. The alarm time will flashon the LCD, meanwhile press HOUR/TUNE- or MIN/TUNE+ button seperately as many times as needed till the required time is reached. After the time flash several times,the radio is set with the alert 1. Then press the POWER button to turn on the radio and listen to the radio.
To cancel the alert time, press the 1/AL1 button again, the alert is cancelled. To select second alert, use the button 2/AL2 Set button as the step stipulated above.
3.When you hear the unit alarm, press SNOOZE button, the radio will stop alarm, but 8 seconds later, the radio will alarm again.
Note: You have to choose AM/PM Properly.4