Kambrook KBV50T manual Cleaning and replacing filters, Motor protection filter, Exhaust filter

Cleaning and replacing filters

Filters must be cleaned from time to time to remove the fine dust particles that have been collected.

1.Remove the dust container from the unit by pressing down on the “Press and Lift” button

2.Then press the “Push to Empty” button. The bottom of the container will release. Take off the filter bracket by holding onto the shaft and turning the filter in an anti-clockwise direction and the filter and its bracket will be released.

3.To remove the metal filter bracket, simply lift it vertically. The filter bracket can be rinsed in luke warm water. Ensure you let the filter bracket completely dry naturally before next use.

4.Shake and tap the HEPA filter until

all the fine dust particles are removed. However, after approximately 6 months the HEPA filter should be replaced.

5.To place the filter back in the dust container simply place the metal filter bracket directly over the HEPA filter, ensure that the metal filter holder is completely dry before use. Ensure that the grooves on the HEPA filter holder and metal filter bracket fit into place.

6.Simply place the filter unit in the dust container lid and turn the filter unit in a clockwise direction until it is clicked in place. Close the bottom of the container.

7.Place the dust container back in the vacuum cleaner for next use.

Motor protection filter

The motor protection filter must always be in place when operating the vacuum otherwise damage to the motor may occur.

To replace the motor protection filter

-remove the dust container. The motor protection filter is located at the bottom of the inner chamber. Pull the filter upward to remove then simply replace the new filter.

Exhaust filter

The exhaust filter should be cleaned every six months. Simply unclip the grill at the back of the vacuum cleaner and shake and tap the filter to remove any dust accumulated. Then relocate the filter and reattach the grill.

Care and Maintenance

Always switch appliance off, then switch off at the power outlet and unplug the appliance prior to cleaning or replacing either filter.

To clean the outside of the unit, wipe the exterior with a soft, damp cloth. Never use an abrasive cleaner.

Check and replace both the motor protection and HEPA filters approximately twice

a year or when visibly clogged.

Notes



KBV50T.indd 6-7



2/8/07 9:34:42 AM