Using Your Carbon Tower Heater
Remove any promotional material or packaging from the heater.
Unwind the cord to its full length and place the heater on a firm, level surface in a stable upright position. Visually inspect the air inlet and outlets to ensure there are no blockages.
Assembling Your Heater
Remove all items from the packaging
-the carbon tower body, front and rear bases. Unscrew the two screws from the base of the tower body.
To join the front and rear bases together, initially feed the cord between the two parts of the base.
Position the front base over the corresponding posts of the rear base, and press down to fit the bases together. Ensure the cord remains within the channel formed when the two halves come together.
Use the screws provided to secure the tower body to the base.
Clip the cord into the straight slot, running from the centre to the edge of the base. Ensure the cord is tidily fitted into the channel, and flush with the base.
Turn the Carbon Tower Heater back to an upright position. It is now ready to use.
Turn the carbon tower body upside down. Align and position the base over the corresponding posts on the rear of the tower body. Push down the base onto the tower body until it is firmly held into position.
Turning Your Heater On
Always place the heater on a firm, level surface in a stable upright position.
Ensure the MODE dial is turned to the OFF position, and the TIMER dial is turned to the 0 MINS position.
Plug the cord into a 230V or 240V power point and switch on.
NOTE: To avoid an electrical circuit overload, it is recommended that no other appliances are plugged into the same circuit as your heater, when it is in use.
The
8
KCF200_IB_V4.indd 8 | 21/10/09 9:34 AM |
