Using Your Kambrook Arctic Pedestal Fan
Before First Use
Remove any promotional material from the fan.
IMPORTANT: When unpacking the fan, check to see you have received all the items listed in the Parts List, before discarding the packaging.
Assembling Your Arctic
Pedestal Fan
Base and Pedestal Tube Assembly
1.Interlock the
Fig. 1
2.Loosen and remove the Height Adjustable Ring. Slide the
2) Extend the support tube. A bit of force may be required to grasp the support tube, located inside the Pedestal Extension Tube.
Fig. 2
3.Place the motor head housing onto the Pedestal Extension Tube.
4.Tighten the screw to secure the motor head housing to the Pedestal Extension Tube.
Fan Head Assembly
1.Remove the Blade Cap from the Motor shaft by turning it clockwise, and then remove the Guard Locking Nut by turning it
2.Thread the Motor shaft through the centre hole of the Rear Grille, placing the Rear Grille into position. Make sure that the carry handle, on the back of the Rear Grille is located above the motor housing. Ensure the Rear Grille is aligned with the locating pins and fix the grille into position by replacing the Guard Locking Nut. Make sure that the Rear Grille has not slipped off the locating pins before tightening. This should be done by hand. Do not force.
NOTE: When positioning the Rear Grille on the Motor shaft, always ensure the carry handle on the grille is positioned in the upright position.
3.Insert the Plastic Blade onto the Motor shaft, and match the pin slots in the blade with the Motor shaft pin.
4.Fix the blade into place by tightening the Blade Cap onto the Motor shaft in an
6
KFA413B_IB_D11_FA.indd 6 | 28/07/11 3:29 PM |