16.Do not run the cord under carpeting or cover the cord with rugs, runners or the like. Arrange cord away from traffic areas and where it will not be tripped over.
17.To disconnect heater turn the control to OFF, then switch off at the power outlet then remove plug from its outlet.
18.Do not insert or allow foreign objects to pass through the inlet or outlet openings.This may cause an electric shock, fire or damage the heater.
19.To prevent a possible fire or heat damage, allow ample space around the heater (at 1.7m at front and 0.5m at the rear, top and sides) and do not totally or partially block the air inlet or outlets in any manner. Check the openings from time to time for accumulated dust. Ensure long shag carpet does not obstruct airflow under the unit.
20.Do not touch hot metal surfaces.
21.Switch off at the control switch and power outlet, then unplug and allow heater to cool down before cleaning or storing.
22.Use this heater only as described in this instruction manual. Any other use not recommended by the manufacture may cause fire electric shock or injury and voids all warranties.
23.Regularly inspect the supply cord, plug, control settings, air inlets and outlets and main housing for any damage. If found damaged in any way, immediately cease use of the heater and return to
Kambrook or an authorised service agent for inspection or repair.
24.The installation of a residual current device (safety switch) is recommended to provide additional safety protection when using electrical appliances. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit. See your electrician for professional advice.
HOW TO OPERATE
1.Remove your heater from its carton and associated protective wrapping, and unwind the cord to its full length and remove any protective cardboard or foam that may have been used to minimise transportation damage.
2.Place the heater on a firm, level surface in a stable upright position.
3.Visually inspect the air inlet and outlets to ensure no foreign material is blocking these areas.
4.Make certain the selector knob is turned to the OFF “O” position and temperature knob to “MAX”.
5.Plug the power cord in a
6.Control the heater with the selector knob and temperature knob, as follows:
The selector knob has 4 settings:
O Shuts of both heater and fan
*Turns the fan on and gives cool air only
I Gives warm air with half heating power
IIGives hot air with maximum 2400 watts of power
The temperature knob (HEAT) acts as an automatic thermostat:
•Turn both selector and temperature knob to high / max settings
•Once a comfortable room temperature has been reached, slowly turn the temperature knob anti- clockwise until you hear a click and the heater turns off.
•At this setting your heater will automatically cycle on and off to maintain the desired room temperature.
Thermoguard Overheating
Safety Device
Your heater is fitted with a safety device that switches off the heater in the event of overheating. Should this heater stop working, turn off the heater and inspect for blockages or air inlet or outlets.Wait at least five minutes for the protection system to reset before attempting to restart the heater.
If the heater fails to operate or the safety device switches off again, return the heater to your nearest service centre for examination or repair.
CARE AND MAINTENANCE
•Always turn off and then unplug the heater before cleaning
•Use only a clean, dry cloth to clean the external surfaces of the heater only.
•If the heater has collected dust or dirt inside the unit or around the elements, have the unit cleaned by a qualified service agent. Do not operate the heater in this condition.
•Do not attempt to open the case of the heater at any time there are no customer serviceable parts inside.
•When not in use, pack the heater, preferably in its original box for best protection and store in a cool, clean and dry location.
4 | 5 |
