Do not run the cord under carpeting or cover the cord with rugs, runners or the
HOW TO OPERATE
FAN/HEAT SELECTOR | CARE AND MAINTENANCE |
like.Arrange cord away from traffic areas and where it will not be tripped over.
To disconnect heater turn control to OFF then switch off at the power outlet then remove plug from its outlet.
Do not insert or allow foreign objects to pass through the inlet or outlet openings, this may cause an electric shock, fire or damage the heater.
To prevent a possible fire, allow ample space around the heater (at least1.7m at front and 0.5m at the rear, top and sides) and do not block air inlets or outlets in any manner. Check the openings from time to time for accumulated dust. Ensure long shag carpet does not obstruct airflow under unit.
Do not touch hot metal surfaces.
Switch off at control switch and power outlet, then Unplug and allow heater to cool down before cleaning or storing.
Use this heater only as described in this instruction manual.Any other use not recommended by the manufacture may cause fire electric shock or injury and voids all warranties.
1.Remove heater from its carton and unwind the cord to its full length.
2.Place heater on a firm level surface, in a stable upright position.
3.Make sure the Selector Knob is turned to OFF “O”.
4.Plug the cord into a
5.Control the heater with the Selector Knob, as follows:
The Selector Knob has 4 settings:
Shuts off both heater and fan
Turns fan on and gives cool air
Gives warm air with half heating power
Gives hot air with maximum heating power
Note: There is a tip over switch on the base. When the heater tips over, it will turn off automatically.
OVERHEATING
SAFETY DEVICE
Your heater is fitted with a safety device that switches off the heater in the event of overheating. Should the heater stop working, turn the heater off and inspect for blockage of air inlet or outlet.Wait at least 5 minutes for the protection system to reset before attempting
to restart the heater.
If the heater fails to operate or the safety device switches the heater off again, return heater to your nearest service centre for examination or repair.
1.Always turn off and unplug the heater before cleaning.
2.Use only a clean, dry cloth to clean the external surfaces of the heater only.
3.If the heater has collected dust or dirt inside the unit or around the element, have the unit cleaned by a qualified service agent. Do not operate the heater in this condition.
4.Do not attempt to open the case of the heater at anytime, there are no customer serviceable parts inside.
5.When not in use, pack the heater in its original box for best protection and store in a cool, clean and dry location.
4 | 5 |
