Before first use, Assembling/Operating the Frost Factory

Before first use

Remove all packaging material and promotional labels. Wash the ice chamber and base in warm, soapy water, rinse and dry thoroughly.

Wipe the motor body with a damp cloth.

Place water in the freezer container leaving 1cm from the top to place the lid on.Then place the container in the freezer for 24 hours.

Place the motor body on a flat, dry surface. Ensure the power plug is unplugged from the power outlet.

Place a deep bowl or container onto the base platform to hold shaved ice.

Place the ice chamber into the base by lining up the flat sides and pushing the chamber down.

Once the water in the freezer container has set and formed into ice, remove the freezer container from the freezer.

Remove the block of ice from the freezer container.

Place the ice in the ice chamber.

Place the motor body on top of the ice chamber. Plug the cord into a 230/240v power outlet and switch on at the power outlet.

Push the top of the motor housing to start shaving. Release the motor housing to stop shaving.

When ice shaving is complete, unplug the Frost Factory and clean. Please see Disassembling/Cleaning your Frost Factory for directions.

NOTE! Please handle the ice chamber carefully as the shaving blade is sharp. Mis-handling of the blade may cause injury.

Ensure all removable parts have been thoroughly washed and dried before assembly (except motor body).

Ensure the Frost Factory is correctly assembled before operating.

Ensure the Frost Factory is used on a clean, dry surface.

Do not use ice cubes in the ice chamber.

Do not use the ice chamber to store ice.

Do not immerse the motor body, cord or power plug in water or any other liquid.

Do not use harsh abrasives or cleaners.

Do not place any of the removable parts in the dishwasher.

Ensure the Frost Factory has been unplugged from the power outlet.

Remove the bowl of shaved ice from the base platform.

Remove the motor body by lifting it in an upward position. Do not immerse in water.