Important Instructions
When using electrical appliances, basic precautions should always be followed, including the following:
Keep combustible materials such as drapes and other furnishings away from heater.
The heater must NOT be located immediately below a socket outlet.
Extreme caution is necessary when this heater is used by or near children or invalids.
Important – this heater is intended for floor use only. Do not mount on ceiling or walls.
Do not leave heater unattended. Always switch off at power outlet then unplug heater when not in use.
Do not operate any heater with a damaged cord or plug, or if heater has been dropped or damaged in any manner. Return heater to your nearest service centre for examination, electrical or mechanical adjustment or repair.
Do not use outdoors.
This heater is not intended for use in wet or moist locations such as bathrooms or laundry areas. Do not immerse or allow liquids to be spilt on heater.
Place unit well clear of heat sensitive surfaces and where necessary place on a suitable stable inflammable surface.
manner. Check the openings from time to time for accumulated dust. Ensure long shag carpet does not obstruct air flow under unit.
To disconnect heater switch OFF both elements, then switch off at the power outlet prior to then removing the plug from its outlet.
Do not insert or allow foreign objects to pass through the element guard as this may cause an electric shock, fire or damage the heater.
Do not touch hot metal surfaces.
Do not allow power cord to contact hot metal surfaces.
Switch off then Unplug and allow heater to cool down before cleaning or storing.
Do not use the heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
Use this heater only as described in this instruction manual. Any other use not recommended by the manufacturer may cause fire electric shock or injury
and voids all warranties.
Always move the heater with the handle provided at the back.
The installation of a residual current device (safety switch) is recommended to provide additional safety protection when
KNOW YOUR SNUGASABUG RADIANT HEATER
3
2
1 
6 | 5 |
4
How to Operate
Remove your heater from its carton, unwind the cord to its full length.
Place the heater on a level surface
in a stable position. Make certain BOTH element switches on rear of heater are in the OFF position
Plug the power cord in a 240Volt outlet, switch outlet on and then switch the heater to the desired setting.
Temperature Setting
The two elements are controlled by two switches at the back of heater independently.
Switching ON either one of the elements provides a medium warm output.
Switching ON both elements provides high heat.
Switch OFF both elements to turn off the heater.
Care and Maintenance
Always turn off and switch off at power outlet then unplug the heater before cleaning.
Use only a clean, dry cloth to clean the external surfaces of the heater only.
Do not attempt to remove the front grill of the heater.
Do not attempt to open the case of the heater at anytime, there are no customer serviceable parts inside.
When not in use, pack the heater in its original box for best protection and store in a cool, clean and dry location.
Do not run the cord under carpeting or cover the cord with rugs, runners or the like. Arrange cord away from traffic areas and where it will not be tripped over.
To prevent a possible fire, allow ample space around the heater (at least 1.7m at front and 0.5m at the rear and sides) and do not block air inlets or outlets in any
using electrical appliances. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance.
See your electrician for professional advice.
1. Safety tumble proof design
2. Efficient twin quartz elements
3. Stainless steel reflector
4. 2 heat settings
5. Twin safety grills
. Wheels - not shown
Before using your heater, please read these instructions carefully and retain for future reference.
Use a vacuum cleaner regularly to remove dust and fluff from the element and grill.
If the unit has accumulated dust around the elements and grill that cannot be removed with the use of a vacuum cleaner, have a qualified service agent clean the unit. DO NOT operate the heater in this condition.
