Kambrook KSK76 manual Using Your Dome Kettle, Before First Use, Operation Of Your Kettle

Using Your Dome Kettle

Before First Use

Remove any packaging material and promotional labels before using your kettle for the first time.

It is recommended before the first use to fill the kettle to the maximum level with cold tap water, bring to the boil and then discard the water.

Your kettle will only operate when positioned on the power base with the ON/OFF switch in the ‘ON’ position. The kettle will automatically switch OFF once the boiling cycle has been completed.

Operation Of Your Kettle

1.To fill the kettle, remove it from the multi-directional power base and pull up on the lid to open. Fill with the desired amount of water. Do not operate the kettle without water. Never fill the kettle above the ‘MAX’ mark, which is indicated inside the kettle (Fig. 1). Too much water could result in water splashing out of the kettle; too little water will result in the kettle switching off.

Fig. 1

2.Ensure that the lid is fit in place and firmly closed before placing the kettle on the power base.

3.Place the kettle firmly onto the power base and plug the power cord into a 230V or 240V power outlet.

4.Press the ON/OFF switch to the‘ON’ position. The power ‘ON’ light will illuminate.

5.The kettle will automatically switch OFF once the water has boiled. Lift the kettle from the power base and pour the water. Take care to hold the kettle level, especially when filled to the maximum level. To re-boil it may be necessary to wait for a few seconds to allow the control to reset.

6.The kettle should be stored on its power base when not in use. The power outlet should be switched off and the power cord unplugged from the power outlet when not in use.

NOTE: This kettle must only be used with the multi-directional power base supplied. Use caution when pouring water from your kettle as boiling water will scald. Do not pour the water too quickly

NOTE: Never operate the kettle dry - too little water will result in the kettle switching off. Do not fill above the MAX mark as boiling water may splash out from the kettle. The ‘MAX’ mark is shown on the steam tube cap inside the kettle.

7