Regularly inspect the power supply cord, plug and actual appliance for any damage. If found damaged in any way, immediately cease use of the appliance and return unit to the nearest authorised Kambrook centre for examination, replacement
or repair.
OPERATING YOUR KAMBROOK 8 LITRE URN
Remove any promotional and packaging materials before use.
It is recommended that before the first use, the urn is filled to the maximum level, boiled and water discarded.
1.Fully unwind power cord.
2.Place the urn on a dry, level surface.
3.To fill with water, turn the locking lid
Use a small container to fill the urn. Do not fill above the maximum 8 litre mark on the external water window as boiling water may splash out from the urn.
4.After filling the urn, ensure that the lid is replaced and locked firmly into position.
5.Plug the power cord into a 230/240v power outlet and switch on.
6.Turn the variable heat control to ‘5’ for fast boiling.The red power ‘on’ light will illuminate.
When the unit has boiled, select the desired setting from ‘MIN” to ‘4’ to maintain temperature (recommend setting ‘2’ or ‘3’ for tea or coffee).
To pour hot water, place a cup below the
After use, switch the appliance to ‘OFF’, switch the power off at the power outlet and then remove the plug when appliance is not being used and before cleaning.
NOTE:The lid should always be fitted and locked into position when in use.
Use caution when pouring water from the urn, as boiling water will scald. Do not pour the water too quickly.
Do not open the lid when in operation as steam may escape from the top.
Steam may escape from the steam holes on top of the urn. Exercise caution at all times.
Always empty the urn before moving to a new position/location.
Never carry the urn when in operation.
Always use the handles to carry the urn.
SAFETY BOIL DRY
PROTECTION
The urn is fitted with a safety device which protects against overheating should the appliance be operated with insufficient water or has boiled dry. If this occurs, the urn will stop heating.The red power ‘on’ light will turn off.
Switch the appliance to off, switch the power off at the power outlet and allow the urn to cool. Press the safety reset button under the base before refilling the urn.The safety device will then be reset and the urn will be ready for use.
CARE AND CLEANING
Always switch the appliance to ‘OFF’, switch the power off at the power outlet and then remove the plug before cleaning. Never immerse the urn controls or cord in water, or allow moisture to come in contact with these parts.
Removal of mineral deposits
Mineral deposits in tap water may cause the urn element plate to discolour.This may be removed by using a commercial kettle descaler which is available from most leading supermarkets, department and hardware stores. Alternatively;
1.Fill the urn until 2/3 full with 1 part vinegar and 2 parts water. Boil and allow to stand overnight.
2.Empty the solution from the urn. Fill the urn with clean water, bring to boil and discard the water. Repeat and the urn will be ready for use.
To clean the exterior
The outside of the urn may be wiped over with a damp cloth and polished with a soft, dry cloth.
NOTE: Do not use chemical, steel wool, or abrasive cleaners to clean the urn.
4 | 5 |
