Using Your Kambrook Jaguar Vacuum Cleaner
Remove all packaging from the unit, hose and other accessories; ensure that you have removed all of the accessories before discarding the packaging.
Ensure that the dust bag and filters are correctly fitted.
Locate the crush proof hose and push the connection point into the hose inlet connection on the top of the unit, until a “click” sound is heard.
Connect the wide end of the metal wand to the hose end, and push together firmly.
Fit the floor tool to the narrow end of the wand/s and push together firmly.
Fully extend the power cord by pulling the power plug (situated at the rear of the unit) out from the unit, until the red/yellow tape on the cord is shown.
ENSURE THAT YOU DO NOT OVER EXTEND THE POWER CORD – DO NOT EXTEND PAST THE RED/YELLOW WARNING TAPE ON THE CORD
Plug into a 230/240v power point and switch the power on.
To commence vacuuming push down on the on/off foot pedal, at the top, rear of the unit. 
When vacuuming is complete, push down on the ‘on/off’ pedal to switch off.Turn the power off at the outlet and then remove the power cord from the power outlet (when removing plug from the power outlet grasp the plug not the cord).
To retract the cord push down on the ‘cord rewind’ pedal. 
IMPORTANT: HOLD THE PLUG END WHEN RETRACTING THE CORD TO PREVENT IT FROM STRIKING YOU OR THE VACUUM.
ALWAYS ENSURE THAT THE DUST BAG AND THE MOTOR PROTECTION FILTER ARE CORRECTLY FITTED. NEVER OPERATE WITHOUT THE DUST BAG OR FILTERS IN PLACE.
Variable Power Control
The variable power control slide switch is located on the top of the vacuum cleaner. Slide the control to the right for maximum power for vacuuming hard floor and carpet surfaces. Slide the control to the left at the minimum power level when using the crevice and brush tools.
Crevice and brush tool accessories
The crevice tool is ideal for vacuuming hard to reach places such as the edges along skirting boards.
The brush tools can be used to vacuum delicate surfaces and areas such as shelves and venetian blinds.
Set the variable temperature control between minimum and medium power when using the tool accessories.
Separate crevice and brush tools are located inside the
4
