Karcher K 2.01 manual Extension Cords, WATER SUPPLY Cold Water Only

Models: K 2.01

1 15
Download 15 pages 11.1 Kb
Page 5
Image 5
Extension Cords

Extension Cords

!Use only extension cords with a suf- ficient gauge.

Up to 25 ft = 12/3 AWG; 25 to 50 ft = 10/3 AWG.

!Use only extension cords that are in- tended for outdoor use. These ex- tension cords are identified by the marking “Acceptable for use with outdoor appliances; store indoors while not in use.”

!Use only extension cords having an electrical rating not less than the ra- ting of the product.

!Do not use damaged extension cords.

!Examine extension cord before using and replace if damaged.

!Do not abuse extension cord and do not yank on any cord to disconnect.

!Keep cord away from heat and sharp edges.

!Always disconnect the extension cord from the receptacle before dis- connecting the product from the ex- tension cord.

!If you are using an extension cord, it should always be completely un- wound from the cable drum.

WATER SUPPLY (Cold Water Only)

￿CAUTION

Dirt in the feed water will damage the unit. To avoid this risk, we recommend fitting a water filter.

!Water hose must be at least 1/2 inch or 5/8 inch in diameter.

!Flow rate of water supply must not fall below 2 GPM (gallons per minu- te).

!Flow rate can be determined by run- ning the water for one minute into an empty 5-gallon container.

!The water supply temperature must not exceed 104°F/40°C.

!Never use the pressure washer to draw in water contaminated with sol- vents, e.g. paint thinners, gasoline, oil, etc.

!Always prevent debris from being drawn into the unit by using a clean water source.

￿WARNING

To reduce the risc of electrocution, keep all connections dry and off the ground. Do not touch plug with wet hands.

English 5

Page 5
Image 5
Karcher K 2.01 manual Extension Cords, WATER SUPPLY Cold Water Only