Operation
Before Startup
Illustrations on Page 3
Illustration 
ÎPull out the clamp for the
Illustration 
ÎConnect high pressure hose to trigger gun.
ÎPush the clamp in until it locks. Check the secure connection by pulling on the
Water supply
According to the applicable regula- tions, the appliance must never be used on the drinking water supply 
without a system separator. Use a suitable system separator manufactured by KÄRCHER; or, as an alternative, a system separator as per EN 12729 Type BA. Water flowing through a system separator is con- sidered
Caution
Always connect the system separator to the water supply, never directly to the appli- ance!
Note: Impurities in the water can damage the
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/tech- nical data.
ÎUse a
ÎScrew the coupling element (supplied) to the water connection on the appli- ance.
ÎPush the water supply hose onto the coupling unit, then connect it to the wa- ter supply.
How to draw water from a bucket when using a KÄRCHER Pressure Cleaner KÄRCHER recommends using the suction hose accessory (sold separately) Order no.
STEP 1:
ÎConnect the suction hose to the water inlet on the pressure cleaner and drop the other end into a bucket.
Tip: If you are not using this accessory, coil a hose into the bucket and ensure that you only use a standard hose clamp to connect to the pressure washer.
CLICK FITTINGS MUST NOT BE USED!
STEP 2:
ÎFill up your bucket with water.
STEP 3:
ÎConnect the KÄRCHER power cord to an electricity source and turn on at pow- erpoint. Make sure the high pressure nozzle is not connected and turn the unit on at the ON/OFF switch. Press the trigger on the gun - the unit is ready for use once there is a constant water sys- tem.
6English
