6 English
Mount loose parts delivered with appliance
prior to start-up.
Illustrations on Page 5
Illustration
ÎInsert the transport handle and screw
in.
Illustration
ÎInsert the transport wheels and lock
them.
ÎAttach the wheel caps.
Illustration
ÎPull out the clamp for the high-pressure
hose from the trigger gun (e.g. a small
screwdriver).
Illustration
ÎConnect high pressure hose to trigger
gun.
ÎPush the clamp in until it locks. Check
the secure connection by pulling on the
high-pressure hose.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
ÎUse a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
ÎScrew the coupling unit (supplied) to
the water connection on the appliance.
ÎPush the water supply hose onto the
coupling unit, then connect it to the wa-
ter supply.
Caution
Never operate the high-pressure cleaner
when the tap is turned off as dry running will
damage the high-pressure pump.
ÎConnect the high pressure hose to the
high pressure connection of the appli-
ance.
ÎPush the spray lance into the trigger
gun and fasten it by turning it through
90°.
ÎCompletely open the water tap.
ÎInsert the mains plug into the socket.
ÎTurn on the appliance “I/ON”.
Before Startup Water supply
Water supply from mains
Start up