GROUND FAULT CIRCUIT INTER-
RUPTER PROTECTION
This product is provided with a ground- fault circuit interrupter (GFCI) built into the plug of the
Should replacement of the plug or cord become necessary, use only identical replacement parts that include GFCI protection.
Contact Kärcher Customer Support.
WATER SUPPLY (Cold Water Only)
CAUTION
When connecting the water inlet to the water supply mains, local regulations of your water company must be observed. In some areas the unit must not be con- nected directly to the public drinking wa- ter supply. This is to ensure that there is no feedback of chemicals into the water
supply. Direct connection via a receiver tank or backflow preventer, for example, is permitted.
Dirt in the feed water will damage the unit. To avoid this risk, we recommend fitting a water filter.
Garden hose must be at least 5/8 inch in diameter.
Flow rate of water supply must not fall below 2 GPM (gallons per minu- te).
Flow rate can be determined by run- ning the water for one minute into an empty
The water supply temperature must not exceed 104°F/40°C.
Never use the pressure washer to draw in water contaminated with sol- vents, e.g. paint thinners, gasoline, oil, etc.
Always prevent debris from being drawn into the unit by using a clean water source.
ASSEMBLY INSTRUCTIONS
Required tools
Screwdriver, small size (not supplied) for connecting high pressure hose and trigger gun.
Assembly
ÎSTEP 1:
Connect the detergent suction tube to the pressure washer.
ÎSTEP 2:
Attach the high pressure hose to the trigger gun.
APull out the locking slide from the right side of the trigger gun handle.
BInsert the small end of the high pres- sure hose into place.
CPush the locking slide back into the trigger gun to lock the hose in posi- tion.
English 5
