IMPORTANT PRECAUTIONS – continued
Water Supply (Cold Water Only)
•Water hose must be at least 1/2 inch or 5/8 inch in diameter.
•Flow rate of water supply must not fall below 2 GPM (gallons per minute).
•Flow rate can be determined by running the water for one minute into an empty
•The water supply temperature must not exceed 104°F/40°C.
•Never use the pressure washer to draw in water contaminated with solvents, e.g. paint thinners, gasoline, oil, etc.
NOTE: Dirt in the feed water will damage the unit. To avoid this risk, we recommend fitting a water filter.
•Always prevent debris from being drawn into the unit by using a clean water source and an accessory water filter if required.
•Save these instructions!
ASSEMBLY INSTRUCTIONS
4
Step 1
Insert wheels into side holes at the bottom of the pressure washer and snap into place.
Step 2
Place the wheel carriage onto the mounting brackets on the sides of the washer and align the four holes. Snap into place.
Step 3
Slide the handle into the top
slot of the wheel carriage and snap into place.
Step 4
Slide the trigger gun holder into track on the right hand side of the pressure washer.
Step 5
Pull out the locking slide from the right side of the trigger gun handle, and insert the small end of the high pressure hose into place. Push the locking slide back into the trigger gun to lock the hose in position.
