You will need a standard screw driver OR a Torx T-25 screw driver
Step4 Slide the spray wand
extension into the gun. Turn the wand
collar clockwise onto the gun threads
until tight.
3
ASSEMBLY INSTRUCTIONS
Step3 Slide the hose caddy into the handle
slots and snap into place.
Step1 Attach the mobile adapter brackets to
the pressure washer. Align holes on the bottom
of the pressure washer as shown and tighten the
4 screws.
Step2 Spread handle sides
apart and align with slotted areas of
mobile adapter brackets and snap into
position. Tighten the 4 screws.

Water Supply

(Cold Water Only)

• Water hose must be at least 3/4 inch in
diameter.
• Flow rate of water supply must not fall
below 2.5 GPM (gallons per minute).
• Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
IMPORTANT PRECAUTIONS – continued
• The water supply temperature must not
exceed 104°F/40°C.
Never use the pressure washer to draw in
water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.
Always prevent debris from being drawn
into the unit by using a clean water source.