K3300G Manual 11/30/01 4:59 PM Page 4
ASSEMBLY INSTRUCTIONS | OPERATING INSTRUCTIONS |
No tools required.
Step 1 Attach the handle to the frame of the | Step 2 Slide the wand extension |
pressure washer. Align holes, insert bolt, and | into the gun. Turn the wand collar onto |
tighten with knob. | the gun threads until tight. |
Step 1 Connect the high pressure hose to | Step 2 Insert the spray wand of |
the unit’s high pressure outlet. | your choice into the wand extension. |
| Press in against the spring tension and |
| twist into the locked position. |
4
Step 3 Check oil level. Oil level should always be between the “FULL” and “ADD” marks on the dipstick. Be sure the machine is level when check- ing the oil level. (Refer to the engine’s operating manual for seasonal grades.)
Step 4 Fill gas tank with unleaded gasoline. Do not use leaded gasoline.
Step 3 Connect garden hose to unit’s water inlet.
Step 4 Connect garden hose to the cold water source and turn water on completely.
Step 5 Trigger the gun to eliminate trapped air, wait for a steady flow of water to emerge from the spray nozzle.
Important! Do not run the engine with a high or low oil level as this can cause
engine damage. If you have further ques- tions regarding the engine, please refer to the engine’s operating manual included with the unit.
You are now ready to operate your Karcher 3300 G Pressure Washer.
Step 6
Slide the throttle control to the run position.
Step 7 Push the primer ball three times. Wait 3 seconds between each push. Note: in cold weather push 5 times.
Step 8 Pull the starter handle. If the engine fails to start after 3 pulls squeeze the trigger gun to release pressure, and repeat step 8.