IMPORTANT PRECAUTIONS – continued
Water Supply
(Cold Water Only)
•Water hose must be at least 3/4 inch in diameter.
•Flow rate of water supply must not fall below 2.5 GPM (gallons per minute).
•Flow rate can be determined by running the water for one minute into an empty
•The water supply temperature must not exceed 104°F/40°C.
•Never use the pressure washer to draw in water contaminated with solvents, e.g. paint thinners, gasoline, oil, etc.
•Always prevent debris from being drawn into the unit by using a clean water source.
ASSEMBLY INSTRUCTIONS
You will need a standard screw driver OR a Torx
3
Step 1 Slide each of the mobile adapter brack- ets to the pressure washer. Align the pegs and holes on the brackets. Insert the 4 screws and tighten as shown.
Step 2 Slide the handle onto the mobile adapter brackets as shown, insert screws and tighten.
Step 3 Slide the hose caddy into the handle slots and snap into place.
Step 4 Slide the spray wand exten- sion into the gun. Turn the wand collar clockwise onto the gun threads until tight.
