TROUBLESHOOTING
Disconnect the machine from the power source before making any repair.
Symptom | Cause | Solution |
|
|
|
Motor will not start | On/Off switch is in the “OFF” (O) | Turn switch to the “ON” (I) position |
| position. |
|
|
|
|
| Power cord is not plugged in. | Plug in power cord. |
|
|
|
| Extension cord is too long. | Replace extension cord with either |
| Extension cord is not proper gauge. | “a 25 ft. 12/3 gauge cord or a 50 |
| Extension cord is damaged. | ft. 10/3 gauge cord. |
|
|
|
| Electrical outlet does not supply | Try a different outlet. |
| adequate power. |
|
|
|
|
| Tripped circuit breaker | Reset breaker (power supply) or |
|
| ground fault circuit interrupter. |
|
|
|
Unit does not reach high | Diameter of garden hose is too | Replace with a 3/4 inch garden |
pressure. | small. | hose. |
|
|
|
|
| Check garden hose for kinks, |
| Water supply is restricted. | leaks and blockage. |
|
|
|
| Not enough inlet water supply. | Open water source full force. |
|
|
|
| Water inlet filter is clogged. | Remove filter and rinse out in |
|
| warm water. |
|
|
|
| Spray wand is in low pressure | Turn spray wand to high pressure |
| position. | position. |
|
|
|
Output pressure varies | Not enough inlet water supply. | Turn water on full force. Check |
high and low. |
| garden hose for kinks, leaks or |
|
| blockage. |
|
|
|
| Pump is sucking air. | Check that hoses and fittings are |
|
| air tight. Turn off machine and |
|
| purge pump by squeezing trigger |
|
| gun until “a steady flow of water |
|
| emerges through the nozzle. |
|
|
|
| Water inlet filter is clogged. | Remove filter and rinse out in |
|
| warm water. |
|
|
|
| Discharge nozzle is obstructed. | Blow out or remove debris with a |
|
| “fine needle. |
|
|
|
| Calcified gun, hose or spray wand. | Run distilled vinegar through |
|
| “detergent suction tube. |
|
|
|
11
