IMPORTANT PRECAUTIONS – continued
Water Supply
(Cold Water Only)
•Water hose must be at least 3/4 inch in diameter.
•Flow rate of water supply must not fall below 2.5 GPM (gallons per minute).
•Flow rate can be determined by running the water for one minute into an empty
•The water supply temperature must not exceed 104°F/40°C.
•Never use the pressure washer to draw in water contaminated with solvents, e.g. paint thinners, gasoline, oil, etc.
•Always prevent debris from being drawn into the unit by using a clean water source.
ASSEMBLY INSTRUCTIONS
3
Step 1 Place the transport handle onto the mounting brackets on the sides of the washer and align the four holes. Hold each
Step 2 Slide the hose caddy into the slots on the transport handle and snap into place.
Step 3 Pull out the locking slide from the right side of the trigger gun handle, and insert the small end of the high pres- sure hose into place. Push the locking slide back into the trigger gun to lock the hose in position.
Step 4 Insert the Spray Wand Extension into the trigger gun. Press in against the spring tension and twist into the lock posi- tion. Turn the Spray Wand Extension Collar clockwise until tight.
