Operation
ÎIllustrations on Page 12
Before Startup
Mount loose parts delivered with appliance prior to
Install the storage for hand-spray gun Illustration 
ÎPlace the bottom holder into the recess- es and push forward until it audibly locks in.
Illustration 
ÎInsert the top holder and push down all the way.
Install the storage hook for the mains connection cable
Illustration 
ÎInstall the top storage hook.
Install the dosage regulator for detergent You will need the 2 included screws as well as a Philips screwdriver PH 2.
Illustration 
ÎInsert both detergent hoses onto the hose fittings.
ÎInstall the dosage regulator and con- nect using 2 screws.
Install the transport handle
Illustration 
ÎWind up the
Illustration 
ÎSlide the free end of the coiled high pressure hose through the recesses on the dosage regulator.
Illustration 
ÎAttach the transport handle, insert the bolts into the bores and screw them in.
Illustration 
ÎPress the connecting fitting from the short high pressure hose into the brass intake until it locks into place audibly. Check the secure connection by pulling on the high pressure hose.
Connect the high pressure hose to the hand spray gun
Illustration 
ÎPush the high pressure hose into the trigger gun until it locks audibly.
6English
Note: Make sure the connection nipple is aligned correctly.
Check the secure connection by pulling on the high pressure hose.
Water supply
Warning
According to the applicable regula- tions, the appliance must never be used on the drinking water supply 
without a system separator. Use a suitable system separator manufactured by KÄRCHER; or, as an alternative, a system separator as per EN 12729 Type BA. Water flowing through a system separator is con- sidered
Caution
Always connect the system separator to the water supply, never directly to the appli- ance!
Note: Impurities in the water can damage the
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/tech- nical data.
ÎUse a
included) with a standard coupling. (Minimum diameter 1/2 inch (13 mm), minimum length 7.5 m).
Illustration 
ÎScrew the supplied coupling element to the water connection on the appliance. Push the water supply hose onto the coupling unit, then connect it to the wa- ter supply.
How to draw water from a bucket when using a KÄRCHER Pressure Cleaner KÄRCHER recommends using the suction hose accessory (sold separately) Order no.
STEP 1:
ÎConnect the suction hose to the water inlet on the pressure cleaner and drop the other end into a bucket.
