CAP 200 and 300/HDP 170
Short User guide
Important points to observe:
•Follow all the safety instructions listed in the user manual for HDP 170!
•Ensure free sight to satellite!
•Vehicle must be stationary when a satellite is being searched for (Avoid movement in vehicle)!
•Before driving away again one must check that the antenna is in park position!
Search for satellite
1. Switch on the receiver with the mains switch. If the red LED is illuminated (ready for operation), press the
2. The screen shows for about 10 seconds: |
| 3. After that, the screen indicates for about 20 sec.: |
|
|
|
5. If the satellite signal is not found, the inserti- on mentioned below will apear. Press the OK button in order to start the search mode (the satellite name may vary, depending on the pro- gramme memory position, e.g. HOTBIRD).
4. After initialisation, the last satellite position is approached, the following picture appears:
No signal!
Signal
6. If the satellite signal is found, at first only a small partial picture appears above at right.
Do not stop the search now, since the receiver undertakes a fine tuning in order to optimize signal reception!
(This procedure may last up to two minutes depen- ding on the reception situation)
7. After this, the following insertion will appear and after another few seconds the desired TV programme is shown as full picture:
Note:
The
936.2412/B/0304/1.2e/ZWT