If you must use an extension cord, be sure that the gauge is large enough to carry
the amount of current necessary for your power tool. If not, your tool may
experience a loss of power, excessive voltage drop or overheating. The smaller the
gauge number, the heavier the cord (see table below).
RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT AC 60 HZ TOOLS
TOOL CURRENT RATING CONDUCTOR SIZE IN A.W.G
AMPERE 10FT. 25FT. 50FT. 100FT.
3-6 18 18 18 18
6-8 18 18 18 16
8-10 18 18 18 14
10-12 16 16 14 14
12-16 14 12 12 -
16-20 12 12 12 -
INSERTING/REMOVING ACCESSORIES
Always unplug rotary tool before changing accessories,
changing collets or servicing. The tool could start unexpectedly, causing
serious injury.
To loosen the collet nut:
1. Press the shaft lock button. Rotate the shaft manually until the lock engages
and prevents further rotation.
DO NOT ATTEMPT TO ENGAGE THE SHAFT LOCK WHILE
THE TOOL IS RUNNING.
2. If the collet nut has a hexagonal shape, use a wrench to loosen the collet nut by
turning in the direction of the arrow labeled L in the illustration. The collet nut
must be loose in order to insert or remove accessories.
3. Remove the old accessory (if any) and install the new accessory, being sure to
push it as far as possible into the collet.
4. Tighten the collet nut by hand until snug.
5. Finish tightening the collet by turning the wrench in the direction of the arrow
labeled T in the illustration. Do not overtighten.
14
MAINTENANCE AND CLEANING
Always UNPLUG the Rotar y Tool from the power source
before inspecting, performing any maintenance or cleaning.
This Rotary Tool is lubricated before it leaves
the factory. This lubrication should last for the life of the tool. No further
lubrication is required.
Use only mild soap and a damp cloth to clean the tool. Never let any liquid get inside
the casing. Never immerse any part of the tool in a liquid. Always keep the ventila-
tion openings clear.
Brushes will wear with use and should be inspected periodically by qualified
personnel.
Regularly clean the ventilation slots in your tool using only a soft brush or dry cloth.
Never open the Rotary Tool case. Do not attempt to repair the Rotary Tool yourself.
Opening the case will void your warranty.
ACCESSORIES
Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may become hazardous when used on
another tool.
Always attach grounded (3-prong) extension cords to grounded (3-hole) outlets.
This product should be grounded. In the event of an electrical short circuit,
grounding reduces the risk of electric shock by providing an escape wire for the
electric current. This product is equipped with a cord having a grounding wire with
an appropriate grounding plug. The plug must be plugged into an outlet that is prop-
erly installed and grounded in accordance with all local codes and ordinances.
13