REMOVING / ATTACHING BATTERY PACK
CHARGING BATTERY PACK USING CHARGER #690072 / ADAPTER #690074
REMOVE BATTERY PACK: |
| |
1. | Press both release |
|
| buttons on either |
|
| side of the Cordless |
|
| Reciprocating Saw to |
|
| release the battery pack. |
|
2. | Pull battery pack free of |
|
| Cordless Reciprocating Saw. | RELEASE BUTTON |
ATTACH BATTERY PACK:
1. Align the raised portion of the battery pack with the groove in the battery compartment of the Cordless Reciprocating Saw.
2.Press the battery pack into place. Make sure the latches are securely fastened. Do not use the Cordless Reciprocating Saw if the battery pack is not seated properly.
CHARGE BATTERY PACK:
1.Make sure the trigger on the Cordless Reciprocating
Saw is in the “OFF” posi- tion and remove the battery pack from the Cordless Reciprocating Saw.
2. Insert the battery pack into
the charger. Be sure that the battery pack is fully seated in the charger. Do not force.
3.Plug the charger into the nearest 120 volt, electrical
outlet. The indicator light will come “ON”.
BATTERY PACK
120V AC
ADAPTER
LED LIGHT
BATTERY
CHARGER
CHARGER #690072 / ADAPTER #690074
Before using battery charger, please read carefully all instructions and cautionary markings on battery charger, battery pack and product using battery.
The charger will not automatically turn “OFF” when the battery pack is fully charged. The charging indicator light will remain “ON” until the charger is disconnected from the electrical outlet.
Use only the charger which accompanied your product or direct replacement as listed in this manual. Do not substitute any other charger. Use only Alltrade approved chargers with your product.
Do not disassemble charger.
Do not use charger if it has been damaged, left outdoors in the rain, snow, wet or damp environments, or immersed in liquid.
The battery pack and charger heat during charging. Place the charger on a flat,
When the battery pack requires recharging, a
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your Cordless Reciprocating Saw continuously, the batteries in your battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, the red light on the charger will flash. When the bat- tery pack cools down, the red light will glow continuously.
This will occur when continuous use of your Cordless Reciprocating Saw causes the battery pack to become hot. It does not occur under normal circumstances.
ONE HOUR CHARGER #690507
Before using battery charger, please read carefully all instructions and cautionary markings on battery charger, battery pack and product using battery.
Use only the charger which accompanied your product or direct replacement as listed in this manual. Do not substitute any other charger. Use only Alltrade approved chargers with your product.
Do not disassemble charger.
Do not use charger if it has been damaged, left outdoors in the rain, snow, wet or damp environments, or immersed in liquid.
11 | 12 |
