Avoid Service
Checklist
OCCURRENCE
Dryer does not start.
Dryer runs but won't heat.
Before calling for service, review this list. It may save both time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this dryer.
POSSIBLE | CAUSE | SOLUTION |
|
Electrical power | cord is not securely | Make sure the plug fits tightly | in wall outlet. |
plugged in or plug may be loose. |
|
| |
House fuse blown or circuit breaker | Reset circuit breaker or replace fuse. | ||
tripped. |
|
|
|
|
| Make sure electrical line is not overloaded and the dryer is | |
|
| on a separate circuit. |
|
Thermal limiter | tripped. | Call authorized service person | for replacement. |
There are 2 house fuses in the dryer circuit. | Replace fuse. |
| |
If 1 of the 2 fuses is blown, the drum may |
|
| |
turn but the heater will not operate. |
|
| |
Gas supply valve is not open (gas models).
Dryer does not have anough air supply to support the burner flame (gas models).
LP gas supply tank is empty or there has been a utility interruption of natural gas (gas models).
Drying cycle takes too long, Lint screen is clogged with lint. outsideofthedryerfeelstoo
hot or smells hot.
Exhaust duct requirements have not been met.
Electric dryer is connected to a 208 volt
|
| circuit, |
|
|
|
|
| Drying procedures have not been | |||
|
| followed. |
|
|
|
|
| Outside exhaust hood or exhaust duct may | |||
|
| be clogged | or restricted. | ||
|
| High humidity. |
|
| |
Excessive | wrinkling. | Dryer is overloaded. |
|
| |
|
| Items left in dryer too | long. | ||
|
| Insufficient | sorting | of | items. |
|
| Drying temperature | too high. | ||
Scratching | or chipping of the | Foreign objects such as coins, pins, clips or | |||
drum finish. | buttons are inside the dryer. | ||||
|
| ||||
Permanently attached items such as belt buckles, zippers and fasteners may be hitting the inside of the drum.
Check to make sure supply valve is open. See INSTALLATION INSTRUCTIONSfor procedure.
See INSTALLATION INSTRUCTIONS.
Refill or replace tank.
Dryer should heat when utility service is restored.
Make sure all lint has been removed from the dryer lint screen before starting each cycle.
Exhaust duct must be at least 4 inches in diameter and
made of rigid or flexible metal.
When in place, the duct must have no more than two 90 ° bends and must not exceed length listed in
INSTALLATION INSTRUCTIONS.
Drying time will be 20% longer than drying on a 240 volt circuit.
SeeDrying Procedures.
Clean out any obstruction.
Use a dehumidifier near the dryer.
Do not overload. See Drying Procedures.
Remove items as soon as cycle ends.
SeeDrying Procedures.
Follow fabric care label instructions.
Always remove foreign objects from pockets before laundering. Remove objects from drum and restart dryer.
It may be necessary to baste a scrap of material securely around ornaments before drying to prevent scratching and damage to the dryer.
Drum damage caused by foreign objects or permanently attached items is not covered by the warranty.
