Kenmore 15592, 15595 manual Troubleshooting Guide, Dishes are not cleaned completely

Models: 15595 15592

1 22
Download 22 pages 41.34 Kb
Page 16
Image 16
Troubleshooting Guide

Troubleshooting Guide

Dishwasher is not operating properly

PROBLEM...

Dishwasher does not run or stops during a cycle

Dishwasher will not fill

Dishwasher seems to run too long

Water remains

In dishwasher

Detergent remains In covered section of dispenser

White residue appears on front of access panel

Odor In the dishwasher

Condensation on kitchen counter

CAUSE...

Door not closed

Wrong cycle selected

No or improper power supplied to dishwasher

Motor stopped due to overload

No water supplied to dishwasher

Overfill protector stuck

Water supplied to dishwasher is not hot enough

Cycle not finished

Cycle not finished

Detergent has lumps Bottom rack in backwards

Too much detergent was used

Brand of detergent developing excess foam

Dishes only washed every 2-3 days

Plastic smell of new dishwasher

Excessivemoisture from vent in dishwasherconsole

SOLUTION...

Make sure door is closed and securely latched.

Refer to the "Cycles" section, page 11.

Check to see if household fuse or circuit breaker is blown or tripped.

Motor will automatically reset itself within a few minutes. If it does not restart, call for service.

Check to see if shut-off valve (if installed) is turned on.

Check to see if the overfill protector moves up and down freely. Press down to release.

It is normal for the dishwasher to run longer while heating water. Refer to the =Water temperature tips" section, page 10.

oThree delays will occur if the Pots & Pans cycle is selected.

The final rinse will automatically delay until the water temperature reaches the proper temperature.

Wait for the cycle to complete.

Wait for the cycle to. complete.

Replace with dry, lump-free detergent.

Refer to the "Parts and Features" section, page 3, and reinstall rack if necessary.

Refer to the "Using the detergent dispenser" section, page 9.

Try a different brand to reduce foaming and eliminate buildup.

Run a Quick Rinse cycle at least once or twice a day until full load is accumulated.

Run a vinegar rinse, as described on the next page.

Dishwasher console should be aligned with countertop. Refer to Installation Instructions for more information.

Dishes are not cleaned completely

Food soil left

Improper loading

on dishes

 

 

Water temperature is too low

 

Use of incorrect, too little,

 

or ineffective detergent

Refer to the "Loading Your Dishwasher" section,

pages 7 and 8.

If needed, turn home water heater up to ensure water entering dishwasher is 120°F (49°C) minimum. Refer to the "Water temperature tips" section, page 10.

Use recommended dishwasher detergents only. Refer to the "Using the detergent dispenser" section, page 9.

Never use less than one tablespoon per load. Detergent must be fresh to be effective. Always store detergent in a cool, dry area.

continued on next page 15

Page 16
Image 16
Kenmore 15592, 15595 manual Troubleshooting Guide, Dishes are not cleaned completely, Dishwasher is not operating properly