Kenmore 17801 Troubleshooting Guide, Dishes are not cleaned completely, Problem Cause, Solution

Models: 16801 17808 15801 15808 15850 17805 16805 17801 16808

1 26
Download 26 pages 6.94 Kb
Page 19
Image 19

Troubleshooting Guide

Dishwasher is not operating properly

PROBLEM ...

CAUSE ...

 

Dishwasher

does not

Door not closed

 

run or stops

during

Wrong cycle selected

a cycle

 

 

No or improper power

 

 

 

 

supplied to dishwasher

 

 

Motor stopped due to

 

 

overload

 

 

 

No water supplied

to

 

 

dishwasher

 

Dishwasher

will

Overfill protector

stuck

not fill

 

 

 

Dishwasher

seems

Water supplied to dishwasher

to run too long

is not hot enough

 

Water

remains

 

Cycle not finished

in dishwasher

 

 

Detergent

remains In

Cycle not finished

covered section of

Detergent has lumps

dispenser

 

 

Bottom rack in backwards

White

residue

ap-

Too much detergent

pears

on front

 

was used

of access

panel

Brand of detergent

 

 

 

 

developing excess foam

Odor

in the

 

Dishes only washed every

dishwasher

 

 

2-3 days

 

 

 

 

Plastic smell of new dishwasher

Condensation

on

Excessive moisture from vent in

kitchen counter

dishwasher console

Dishes are not cleaned completely

Food soil left

Improper loading

on dishes

 

 

Water temperature is too low

Use of incorrect, too little, or ineffective detergent

SOLUTION ...

Make sure door is closed end securely latched.

Refer to the "Cycles" section, page 12-13.

Check to see if household fuse or circuit breaker is blown or tripped.

Motor will automatically reset itself within a few minutes. If it does not restart, call for service.

Checkto see if shut-off valve (if installed) is turned on.

Check to see if the overfill protector moves up and down freely. Press down to release.

It is normal for the dishwasher to run longer while heating water. Refer to the '_Natertemperature tips" section, page 11.

oA delay will occur in the main wash if the Water Heat option is selected.

Three delays will occur if the Pots & Pans cycle is selected.

The final rinse will automatically delay until the water temperature reaches 135°F (57°C).

Wait for the cycle to complete.

Wait for the cycle to complete.

Replace with dry, lump-free detergent.

Refer to the "Parts and Features" section, page 3 and

reinstall rack if necessary.

Refer to the "Using the detergent dispenser" section, page 10.

Try a different brand to reduce foaming and eliminate buildup.

Run a Quick Rinse cycle at least once or twice a day until full load is accumulated.

Run a vinegar rinse, as described on the next page.

Dishwasher console should be aligned with countertop. Refer to Installation Instructions for more information.

Refer to the "Loading Your Dishwasher" section, pages 7-9.

Use the Water Heat option. If needed, turn home water heater up to ensure water entering dishwasher is 120°F

(49°C) minimum. Refer to the "Water temperature tips" section, page 11.

Use recommended dishwasher detergents only. Refer to the "Using the detergent dispenser" section, page 10. Never use less than one tablespoon per load. Detergent

must be fresh to be effective. Always store detergent in a cool, dry area.

18

Page 19
Image 19
Kenmore 17801 Troubleshooting Guide, Dishes are not cleaned completely, Dishwasher is not operating properly, Solution