Kenmore 1T6.31100 manual Motor Safety Filter Cleaning, Exhaust Filter Replacement

MOTOR SAFETY FILTER CLEANING ]

If the filter, located in the bottom of the

WARNING

Electrical Shock Hazard

Unplug power cord from electrical outlet. Do not operate the vacuum cleaner without the motor safely filter. Be sure the filter is dry and properly installed to

prevent meter failure and/or electrical shock.

MOTOR SAFETY FILTER

Check motor safety filter frequently and clean when dfrtyo

Remove the dust

bag as outlined in the DUST BAG

REPLACEMENTMotor Safety

section,Filtel

dust bag chamber, is dirty, remove it by pulling forward out from under the ribs.

Wash the foam filter in warm soapy water, rinse and dry thoroughly by squeezing the filter in your hand and letting it air dry.

DO NOT wash in the dlshwasher_

DO NOT install damp.

Replace the foam filter by sliding it back into place under the ribs in the dust bag chamber.

Replace the dust bag as outlined in the DUST BAG REPLACEMENT section.

I EXHAUST FILTER REPLACEMENT I

The HEPA exhaust filter must be replaced

when dirty. It should be replaced regularly depending on use conditions.

The filter CANNOT be washed as it will lose its dust trapping abilily_

Note: See PARTSAND FEATURES for the exhaust filter number.

1.Remove exhaust filter cover by

pressing the release tab on

the cover and

rotating out from vacuum

cleaner.

3.Place new filter cartridge into cover making sure that airflow arrow on side of cartridge points into cover_

Place foam seal of filter against the vacuum cleaner body_

Exhaust

Filter

"_--Exhaust

2. Remove the

filter cartridge from cover.

Filter

4.Replace the exhaust filter cover by placing bottom tabs in slots and raising cover up until it snaps into place

18