Kenmore 3384413A manual Rinse Aid Dispenser, To check water temperature

Rinse Aid Dispenser

Rinse aids prevent water from forming droplets that can dry as

spots or streaks. They also improve drying by allowing water to drain off of the dishes dudng the final rinse by releasing a small amount of the dnse aid into the rinse water. Your dishwasher is

designed to use a liquid rinse aid. Do not use a solid or bar-type.

Checking the dispenser

Check the center of the Fill Indicator cap. Clear means it needs filling.

Or you can remove the Fill Indicator cap. If an "E" is visible, the dispenser is empty,

Riling the dispenser

The rinse aid dispenser holds 6 oz (175 mL) of rinse aid. Under normal conditions, this will last for about three months. You do

not have to wait until the dispenser is empty to refill it. Try to keep it full, but be careful not to overfill it.

1.Make sure the dishwasher door is completely open.

2.Remove the Fill Indicator cap.

3.Add rinse aid. Fill to the smallest opening in the lower part of the dispenser. Overfilling can cause the rinse aid to leak out, and could cause oversudsing.

4.Clean up any spilled rinse aid with a damp cloth.

5.Replace the Fill Indicator cap. Close tightly.

Dishw sher Efficie cy Tips

Hot water dissolves and activates the dishwashing detergent. Hot water also dissolves grease on dishes and helps glasses dry apot-free. For best dishwashing results, water must be at least 120°F (49°C) as it enters the dishwasher. Loads may not wash as well if the water temperature is too low.

To check water temperature

1.Run hot water at the faucet closest to your dishwasher for at least 1 minute.

2.Place a candy or meat thermometer in a glass measuring cup.

3.Check the temperature on the thermometer as the water is running into the cup.

4.If the water temperature at the faucet is below 120°F (49°C),

have a qualified person raise the water heater's thermostat setting.

•To save water, energy and time, do not rinse dishes before putting them into the dishwasher.

•Use a low energy, quick, or short cycle whenever possible. These cycles use less hot water and energy than the Normal cycle.

•Use a delay feature (on some models) to run your dishwasher during off-peak hours. Local utilities recommend avoiding

heavy usage of energy at certain times of day.

•During the summer, run your dishwasher at night. This reduces daytime heat buildup in the kitchen.

•Use the energy-saving dry option whenever possible, Allow longer drying times (overnight) when using these options. Use a rinse aid to improve drying.

•Use cycles or options that add extra heat to the wash or rinse portion of the cycle only when needed.

•Run your dishwasher with full loads. Run a rinse cycle after meals until the dishwasher is full.

11