Basket crooked
•Was the washer basket pulled forward during loading?
Push the basket to the center before starting wash.
•Isthe load balanced and the washer level? The wash load
should be balanced and not overloaded. The washer must be
level. The front feet should be properly installed and the nuts
tightened. Reset the rear leveling legs (if needed). See the
Installation Instructions.
•The washer basket moves while washing. This isnormal.
Agitator operation •
•The top ofthe agitator isloose, or moves in only one
direction. This is normal.
Washer stops, won't fill, rinse or agitate
•Checkthe following:
Isthe power cord plugged into a grounded 3 prong outlet?
Isthe indicator on the Cycle Control knob properly lined up
with acycle? Turn the Cycle Control knob to the right slightly
and pull tostart.
Are the water inlet valve screens clogged?
Are both the hot and cold water faucets turned on?
Isthe water inlet hose kinked?
•Isthe lid open? The lid must be closed to operate.
•Does the water level seem too low, or does the washer
appear to not fill completely? The top of the agitator is
much higher than the highest water level. This isnormal and
necessary for clothes to move freely.
•Has a fuse blown oris the circuit breaker open? If problem
continues, call an electrician.
•Are you using an extension cord? Do not use an extension
cord.
•Isthe washer overloaded? Wash smaller loads.
Washer won't drain or spin
•Isthe drain hose clogged, or the end ofthe drain hose
more than 96 in. (244 cm) above the floor? See the
Installation Instructions for proper installation of drain hose.
Is the lid open? The lid must be closed to operate.
Isthere excessive sudsing? Always measure detergent.
Follow manufacturer's directions.
Washer continues to fill or drain, cycle seems stuck
Isthe top of drain hose lower than the water level in
washer? The top of thehose must be higher than the water
level inthe washer for proper operation. See the Installation
Instructions.
Does the drain hose fit tootightly in the standpipe, or is it
taped to the standpipe? The drain hose should beloose yet
fit securely. Do not seal the drain hose with tape. The hose
needs an air gap. See the Installation Instructions.
Wash temperature not what I selected
•Are the hot and cold water inlet hoses reversed? See the
Installation Instructions for more information. As your
frequency of loads washed increases, the water temperature
may decrease for hot and warm temperature selections. This
isnormal.
NEW VEND PRICE
To change vend price, detach and mail the lower portion to:
Customer Service Department
Greenwald Industries Inc.
212 Middlesex Ave.
Chester, CT06412
Order required parts using this tear-off. Block-out keys will be
shipped to you at no charge. Follow product information
instructions.
Quantity
Existing Vend Price
New Vend Price
The coin chute has been pre-set at the factory.

When increasing in$.25 pricing

Follow product information instructions; no extra parts required.

When decreasing in$.25 pricing- or - changing to

$.10 pricing

(Coinsizing block required;see "Changing Vend Price" section.)

Name
Company
Address
City
Daytime phone
Purchase date
14