Kenmore 415.161278 manual Match-Lighting Do not lean over grill while lighting

Main Burner ignitor Lighting

ADo not lean over grill while lighting.

1.Open lid during lighting.

2.Turn ON valve from source or tank.

3.Push and turn Ignition Burner control knob to_. Hi and immediately press and hold Electronic Ignition button.

4.If ignition does NOT occur in 5 seconds, turn Left Burner control knob OFF, wait 5 minutes for gas to clear and repeat the lighting instructions.

5.To Light Other Burners turn control knob to HI.

If ignitor does not work, follow match lighting instructions.

After Lighting: Turn knobs to HI position for 15 minutes to pre- heat grill. Then turn knob to desired setting for cooking.

ffburner does not light, turn knobs to OFF, wait 5 minutes, and try again. Always close valve during the 5 minute waiting period, if the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidentally ignite with risk of injury.

Match-Lighting

ADo not lean over grill while lighting.

1.Open lid during lighting. Turn on gas at LP tank.

2.Place match into match holder (hanging from side of cart). Light match, place into lighting hole on right side of firebox.

3.Push in and turn right knob to HIGH position. Be sure burner lights and stays lit.

4.Light other burners by pushing knob in and turning to_ Hi position.

Sideburner ignitor Lighting

1.Open lid or cover for Side Burner during lighting.

2.Turn ON valve from source or tank.

3.Push and turn Side Burner control knob to_- HI and immediately press and hold Electronic Ignition button.

4.If ignition does NOT occur in 5 seconds, turn Side Burner control knob OFF, wait 5 minutes, and repeat the lighting instructions.

If ignitor does not work, follow match lighting instructions.

After Lighting: Turn knobs to HI position for warm-up. Sideburner Match Lighting

1.Open top cover. Turn on gas at LP tank.

2.Hold lit match to any port on the burner. Push in and turn

sidebumer knob to _ HI. Be sure burner lights and stays lit.

Before Your First Cookout

,Light burners, check to make sure they are lit, close the lid and warm up grill on HIGH for 15 minutes. This curing of paint and parts will produce an odor only on first lighting.

Burner Flame Check

o Light burner, rotate knobs from HIGH to LOW. You should see

asmaller flame in LOW position than seen on HIGH. Always check flame prior to each use. If only low flame is seen refer to "Sudden drop or low flame" in the Troubleshooting Section.

Hose Check

*Before each use, check to see if hoses are cut, worn or kinked. Replace damaged hoses before using grill. Use only valve/hose/regulator specified in the Parts List.

Normal	Kinked
Hose	Hose

Turning Grill Off

o Turn all knobs to OFF position. Turn LP tank off by turning OPD hand wheel clockwise to a full stop.

ignitor Check

•Turn gas off at LP tank, Press and hold ignitor button. "Click" should be heard and spark seen each time between collector box or burner and electrodes. See "Troubleshooting"if no click or spark.

Valve Check

•_mportant: Make sure gas is off at LP tank before checking valves. Knobs lock in OFF position. To check valves, first push in knobs and release, knobs should spring back. If knobs do not spring back, replace valve assembly before using grill. Turn knobs to LO position then turn back to OFF position. Valves should turn smoothly.

General Grill Cleaning

o Keep the outside of your grill looking new by cleaning it once a month with warm soap and water or a non-abrasive cleaner. If you don'thave a grill cover, wipe off dust and grime before starting your grill.

oCoating the cooking grids with spray-on cooking oil will keep the food from sticking and make clean up easier. After cooking, scrape the grates with a long handled, brass wire bristle brush.

,Check inside the grill bottom for grease build up and clean often, especially after cooking fatty meat.

,Do not mistake brown or black accumulation of grease and smoke for paint. Apply a strong solution of detergent and water or use a grill cleaner with scrub brush on insides of grill lid and bottom. Rinse and allow to completely air dry. Do not apply a caustic grillloven cleaner to painted surfaces,

•Plated wire grates: Wash grates with concentrated grill

cleaner or use soap and water solution. Dry thoroughly and store indoors between cookouts.

8 • 464310808• 464310608