Kenmore 4908 manual Electrical Shock Hazard, Plug into a grounded 3 prong outlet

1.Drape the power cord over the washer top.

2.Move the washer to its final location.

3.Place the drain hose in the laundry tub or standpipe as shown. See illustrations A and B.

ABC

4.If the washer faucets and the drain standpipe are recessed, put the hooked end of the drain hose in the standpipe as shown. See illustration C.

NOTES:

[] Do not force excess drain hose back into the rear of the washer.

[] To avoid siphoning, do not seal the drain hose into the standpipe.

Level your washer by turning the leveling legs in or out as necessary by hand or the wrench included with your washer. When your washer is level, tighten the nuts using the wrench or (-) driver.

NOTES

[] Your Washer must be leveled on all four sides. A carpenter's level should be used on all four corners of your Washer. It's a good idea after the first dozen washes to recheck your washer's levelness.

[] To avoid damage to the legs, do not move the Washer unless the Lockingnuts are fastened to the bottom of the Washer.

1.Check the electrical requirements. Be sure that you have the correct electrical supply and the recommended grounding method. See "Electrical Requirements."

2.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.

3.Check that you have all of your tools.

4.Dispose of or recycle all packaging materials.

5.Check that the water faucets are on.

6.Check for leaks around faucets and inlet hoses.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

7.Plug into a grounded 3 prong outlet.

8.Read "Washer Use."

9.To test and to clean your washer, using only "HE" High Efficiency detergent, measure 1/2the amount of detergent recommended by the manufacture for a medium size load. Pour the detergent into the detergent dispenser. Select NORMAL/CASUAL, and then select START. Allow the washer to complete one whole cycle.

Use only HE High Efficiency detergent.

11