Installing Side Burner Valve

4.Using (2) 1/4 x 10mm screws and (2) 1/4 lock washers, attach side burner shelf to grill head from inside the firebox. Do not tighten screws.

Note: Leaving all screws un-tightened at this point

wilt aid the assembly process.

5. Insert one 5/32 x 8 mm screws to attach the side

shelf to the control panel (Fig 11).

6. Repeat steps 2 through 5 to install side shelf.

1.Remove the two screws attaching side burner to underside of side burner shelf to make room to

install side burner valve. See Figure 12 A inset.

2.Remove two screws from side burner control valve face. Insert side burner valve control stem

through hole in side burner control panel. See Figure 12 B.

3.Place side burner control knob bezel over side burner valve control stem. Secure bezel to control

and valve with 2 screws removed in step 2. Push control knob onto valve control stem. See Figure 13.

4.Insert valve orifice tip into burner tube as shown in Fig. 12. Reattach burner to underside of side burner shelf with screws removed in step 1.

5.Plug ignition wire into igniter wire electrode on

underside of burner(Fig. 14).

6.Secure all side shelf screws at this time for both side shelf and side burner

When you have finished assembling grill, make sure that all screws and nuts are tight and secure.

Installing Battery

1.Unscrew the ignition battery cap. (Found at far left of control panel).

2.Install battery into ignition box with positive terminal facing outward.

3.Replace the ignition battery cap after the battery has been installed. (Fig. 15)

2pcs: ¼ X lOmm

Figure 11

1pc: 5/32 X 8mm

Figure 12

Figure 13

Figure 14

Figure 15

.J .-<

\'\\\\{;