Kenmore 665.16659, 665.16652, 665.16654 manual Troubleshooting

Models: 665.16654 665.16659 665.16652

1 20
Download 20 pages 54.36 Kb
Page 16
Image 16
TROUBLESHOOTING

Checkthedrainairgapanytimeyourdishwasherisn_ drainingwell.

Some state or local plumbing codes require the addition of a drain air gap between a built-in dishwasher and the home drain system, If a drain is clogged, the drain air gap protects your dishwasher from water backing up into it.

Jr

The drain air gap is usually located on top of the sink or countertop near the dishwasher. To order a drain air gap call 1-800-366-7278 and ask for Part Number 300096.

NOTE: The drain air gap is an external plumbing device that is

not part of your dishwasher. The warranty provided with your dishwasher does not cover service costs directly associated with

the cleaning or repair of the external drain air gap.

To clean the drain air gap

Clean the drain air gap periodically to ensure proper drainage of

your dishwasher. Follow the cleaning instructions provided by the manufacturer. With most types, you lift off the chrome cover, Unscrew the plastic cap. Then check for any soil buildup. Clean if necessary.

Storing for the summer

Protect your dishwasher during the summer months by turning off the water supply and power supply to the dishwasher.

Winterizing your dishwasher

Protect your dishwasher and home against water damage due to freezing water lines. If your dishwasher is left in a seasonal dwelling or could be exposed to near freezing temperatures, have your dishwasher winterized by authorized service personnel.

TROUBLESHOOTING

First try the solu_ons suggested here and possibly avoid

the cost of a service call...

Dishwasher is not operating properly

Dishwasher does not run or stops during a cycle Is the door closed tightry and latched?

Is the right cycle selected? Refer to the "Cycle Selection Chart."

Is there power to the dishwasher? Has a househord fuse blown or circuit breaker tripped?

Has the motor stopped due to an overload? The motor automatically resets itself within a few minutes. If it does not restart, call for service.

Is the water shut-off valve (if installed) turned on?

Dishwasher will not fill

Is the overfill protection float able to move up and down freely? Press down to release.

Dishwasher seems to run too long

Is the water supplied to the dishwasher hot enough? The dishwasher runs longer while heating water. Refer to the "Water Temperature Tips" section.

A delay automatically occurs in some wash and rinse cycles until the water reaches the proper temperature,

Water remains in the dishwasher rsthe cycle complete?

Detergent remains in the covered section of the dispenser

Is the cycle complete?

Is the detergent lump-free? Replace detergent if necessary,

Is the bottom rack installed properly with the bumpers in the front? Refer to the "Parts and Features" section. Reinstall th_

rack if necessary.

White residue on the front of the access panel

Was too much detergent used? Refer tc the "Detergent

Dispenser" section.

Is the brand of detergent making excess foam? Try a different brand to reduce foaming and eliminate buildup.

=Odor in the dishwasher

Are dishes washed only every 2 or 3 days? Run a rinse cycle once or twice a day untir you have a full load.

Does the dishwasher have a new plastic smell? Run a vinega= rinse as described in "Spotting and filming on dishes" later in this Troubleshooting guide.

Condensation on the kitchen counter (built-in models)

rs the dishwasher aligned with the counter top? Moisture from the vent in the dishwasher console can form on the counter. Refer to the Installation Instructions for more information.

16

Page 16
Image 16
Kenmore 665.16659, 665.16652, 665.16654 manual Troubleshooting