General Cleaning (continued
Turn the warmer drawer
control knob to OFF before removing the drawer. DO NOTtouch the warmer drawer element. The element may still be hot enough to cause burns, even if it is dark in color.
Warmer Drawer
Avoid Service Checklist
OCCURRENCE
Drawer is not level.
Cannot move appliance easily. Appliance must be accessible for service.
Warmer drawer does not operate.
To Remove | and | Replace Warmer Drawer | |
To Remove Warmer | Drawer: |
| |
1. _ | Turn power | off before removing the warmer drawer. | |
2.Open the drawer to the fully opened position.
3.Locate the latches on both sides of the warmer drawer.
4.Pull up on the left glide latch and push down on the right glide latch.
5.Pull the drawer away from the appliance.
6.To clean warmer drawer, gently scour with a soapy scouring pad; this will remove most spots. Rinse with a 1:1 solution of clear water and ammonia. If necessary, cover difficult spots with an
To Replace Warmer Drawer:
1.Align the glide latches on both sides of the drawer with the slots on the drawer.
2.Push the drawer back into the appliance.
Electrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance
from electric power before cleaning and servicing the warmerdrawer.
Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective
workmanship or materials in this appliance.
POSSIBLE CAUSE/SOLUTION
Poor installation. Place a level on the cutout bottom. Make sure bottom is level.
Be sure cutout bottom is strong and stable enough to adequately support drawer (and wall oven, if applicable).
Cabinets not square or are built in too tightly. Contact builder or installer to make appliance accessible.
Make sure cord/plug is plugged tightly into outlet.
Service wiring is not complete. Contact Sears or another qualified servicer.
Power outage. Check house lights to be sure. Call your local electric company for service.
An error at power up (or after a power failure) could happen if the control knob was left on the ON position. If a power failure should occur, be sure to set the control knob to the OFF position. This will reset the electronic controls.
Once the control knob has been set to the OFF position, the electronic controls should return to normal operation.
