General Cleaning (continued
Turn the warmer drawer
control knob to OFF before removing the drawer. DO NOT touch the warmer
drawer element. The element may still be hot enough to cause burns, even if it is dark in color.
Left Glide | Pull up latch |
| with finger |
Push down latch | Right Glide |
with finger |
|
Warmer | Drawer |
To Remove and Replace Warmer Drawer
To Remove Warmer Drawer:
t. _Turn | poweroff before removing the warmerdrawer. |
2.Open the drawer to the fully opened position.
3.Locate the latches on both sides of the warmer drawer.
4.Pull up on the left glide latch and push down on the right glide latch.
5.Pull the drawer away from the appliance.
6.To clean warmer drawer, gently scour with a soapy scouring pad, this will remove most spots. Rinse with a t :t solution of clear water and ammonia. If necessary, cover difficult spots with an
To Replace Warmer Drawer:
1.Align the glide latches on both sides of the drawer with the slots on thedrawer.
2.Push the drawer back into the appliance.
Electrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance
from electric power before cleaning and servicing the warmerdrawer.
Avoid | Service | Checklist | Before you call | for service, review this list. it may save you time and expense. | |||||
|
|
|
|
| The list includes common occurrences that are not the result of defective | ||||
|
|
|
|
| workmanship or materials in this appliance. |
| |||
OCCURRENCE |
|
| POSSIBLE | CAUSE/SOLUTION |
| ||||
Drawer is not | level. |
| Poor installation. Place a level on the cutout bottom. Make sure bottom | is level. | |||||
|
|
|
|
| Be sure cutout bottom is strong and stable enough to adequately support drawer | ||||
|
|
|
|
| (and wall | oven, | if applicable). |
| |
Cannot move | appliance | easily. | Cabinets | not square | or are built in too tightly. Contact builder or installer | to make | |||
| Appliance | must | be accessible for | appliance | accessible. |
|
| |||
service. |
|
|
|
|
|
|
|
|
|
Warmer drawer | does not operate. | Make sure cord/plug | is plugged tightly into outlet. |
| |||||
Service wiring is not complete. Contact Sears or another qualified servicer.
Power outage. Check house lights to be sure. Call your local electric company for service.
