Kensington DT20 Display the pointer., Select the type of pointer., Mute the image.

E-34
15 Display the pointer.
Press the SET/POINTER button to display the pointer. Press
it again to hide the pointer.
Press the SCROLL button to move the pointer.
NOTE
Adjusting the zoom or the brightness while the pointer is displayed may cause it to disappear momentarily, but it
will reappear after a short time.
16 Select the type of pointer.
You can switch the type of pointer with the POINTER TYPE
button on the remote controller. (Select from , , or .)
You can also select the type from “Pointer type” on the
“Setting 2” menu. See page E-45 for details.
17 Mute the image.
Press the MUTE button to stop projecting the image without
turning off the lamp. You can select the image projected while
the image is muted from the following two images.
qProject a completely black image while the projected
image is muted.
Set “Black” in “Mute mode” on the “Setting 2” menu (page
E-45). While the image is muted, the projecting black
image icon is displayed on the top right side of the
projected image.
wProject an arbitrary image while the projected image is muted.
Set “logo” in “Mute mode” on the “Setting 2” menu (page E-
45).
While the image is muted, the projecting image icon is
displayed on the top right side of the screen.
NOTE
After the projected image has been muted for a certain amount of time (about 15 minutes) it automatically goes
into standby.
Main Unit Operation
Remote Control Operation
MUTE
MUTE
Main Unit Operation
Remote Control Operation
SET
POINTER
POINTER/
SET
Remote Control Operation
POINTER TYPE