DMF-9020/MD-2070 (En)
26
Adjust the settings if required.
1
2
1Switch the REC MODE on.
2Select the setting adjustment mode.
3Set the selection (by pressing the JOG DIAL).
Go to step 2 if setting adjustments are not required.
The input jacks connected with audio cords accept analog signals. This unit records the analog signal from the REC IN jacks by
converting it into digital signal. (This recording is simply referred to as analog recording.)
Recording (ANALOG input)
÷MONO cannot be selected during recording pause.
÷The REC INPUT cannot be changed during pause in the MONO mode.
÷The analog “monaural long-play mode”allows to double the recording
time compared to recording in the stereo mode.
Preparation
Each press switches the mode.
1REC MODE : off
2REC MODE : on
Select ANALOG or MONO.
Each press switches the mode.
1ANALOG : Analog “stereo mode”
2DIGITAL 1 : Coaxial input mode
3DIGITAL 2 : Optical input mode
4DIGITAL 3 : Coaxial input mode
5MONO : Analog “monaural long-play mode”
“ANALOG” lights up
1Open the write protect tab of the Mini Disc to make it recordable. 8
2Load the Mini Disc.
3Check the remaining recording time. o
4Set the amplifier’s input selector to the source to be recorded.
ANALOG recording
÷For details on the setting adjustment modes, see “REC MODE key”.
£
OVER (
−
dB)
R
L
ANALOG
∞
15
912 7 51
3
40 30 21 18 0
SEARCHPGM
MONITOR
ANALOG
32kHz
213
48kHz
44.1kHz
DIGITAL
REC MODE
/CHARAC.
4¢
U PDOWN
PUSH SET
JOG DIAL
4¢
U PDOWN
PUSH SET
JOG DIAL
REC INPUT
The modes are switched by rotating the JOG DIAL.
D. REC LEVEL? : Digital recording level setting.
AUTO CUT? : AUTO CUT on/off selection.
AUTO TIME? : Setting of the time for detecting a no-sound
blank section during automatic track number
marking.
AUTO LEVEL? : Automatic track number marking no-sound
blank detection level and SOUND SYNCHRO
REC, AUTO CUT and REC AUTO PAUSE sound
detection level setting
FADE TIME? : Setting of the fading time in fade-in and fade-
out.
REC= WRITING? : Setting of the UTOC writing after recording.
÷The “D.REC LEVEL” and “FADE TIME” settings are not used during
analog source recording.