before using your Kenwood appliance
●Read these instructions carefully and retain for future reference.
●Remove all packaging and any labels.
safety
●The blades and discs are very sharp, handle with care. Always hold the knife blade by the finger grip at the top, away from the cutting edge, both when handling and cleaning.
●Always remove the knife blade before pouring contents from the bowl.
●Keep hands and utensils out of the processor bowl whilst connected to the power supply.
●Switch off and unplug:
●before fitting or removing parts
●after use
●before cleaning
●Never use your fingers to push food down the feed tube. Always use the pusher/s supplied.
●Before removing the lid from the bowl:-
●switch off;
●wait until the attachment/blades have completely stopped;
●Do not use the lid to operate the processor, always use the on/off speed control.
●This machine will be damaged and may cause injury if the interlock mechanism is subjected to excessive force.
●Never use an unauthorised attachment.
●Never leave the machine on unattended.
●Never use a damaged machine. Get it checked or repaired: see ‘service’.
●Never let the power unit, cord or plug get wet.
●Don’t let excess cord hang over the edge of a table or worktop or touch hot surfaces.
●This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
●Children should be supervised to ensure that they do not play with the appliance.
●Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.
before plugging in
●Make sure your electricity supply is the same as the one shown on the underside of your machine.
Important – UK only
●The wires in the cord are coloured as follows: Blue = Neutral,
Brown = Live.
●The appliance must be protected by a 13A approved (BS1362) fuse.
Note:
●For
●If a
●This appliance conforms to EC directive 2004/108/EC on Electromagnetic Compatibility and EC regulation no. 1935/2004 of 27/10/2004 on materials intended for contact with food.
before using for the first time
1Remove all packaging including the plastic blade covers from the knife blade. Take care the blades are very sharp. These covers should be discarded as they are to protect the blade during manufacture and transit only.
2Wash the parts see ‘cleaning’
3Push excess cord into the back of the machine.
key
processor
pusher feed tube lid bowl
detachable drive shaft speed + pulse control power unit
safety interlock cord storage
attachments
knife blade
emulsifying tool / whisk
thick slicing/coarse shredding disc geared citrus press
spatula
to use your food processor
1 | Fit the detachable shaft onto the power unit . |
2 | Then fit the bowl. Place the handle towards the back and turn |
| clockwise until it locks . |
3 | Fit an attachment over the drive shaft. |
●Always fit the bowl and attachment onto the machine before adding ingredients.
4 Fit the lid - ensuring the top of the drive shaft locates into the centre of the lid.
●Do not use the lid to operate the processor, always use the on/off speed control.
5 Switch on and select a speed.
●The processor won’t work if the bowl and lid are fitted incorrectly.
●Use the pulse control for short bursts. The pulse will operate as long as the control is held in position.
6Reverse the above procedure to remove the lid, attachments and bowl.
●Always switch off before removing the lid. important
●Your processor is not suitable for crushing or grinding coffee beans, or converting granulated sugar to caster sugar.
●When adding almond essence or flavouring to mixtures avoid contact with the plastic as this may result in permanent marking.
2
