Kenwood H2EV Installation in a Vehicle, Placing the Base and Cradle, Option 1 Windshield Mount

Do not use hard cloths or paint thinner, alcohol, or other volatile solvents to clean the unit. These may cause damage or remove indicator characters.

!Warning

6Do not operate the unit in a way that might divert your attention from driving safely. As a driver, you alone are responsible for safely operating your vehicle in accordance with traffic safety laws at all times.

Installation in a Vehicle

Note: Do not put Here2Everywhere in the Car Docking Cradle until you have completed the cradle installation.

Step 1: Placing the Base and Cradle

First, determine where you want to mount

Here2Everywhere.

There are two options for installing the

Here2Everywhere. Select the option and location that provides good visibility of and access to Here2Everywhere’s front panel while maintaining a safe driving experience.

Base nut

Pivot (where the

Cradle attaches)

Pivot

Suction cup base

Button

Lever

	DC12V		ANT
		AUDIOOUT	FMOUT
Power	Audio Output		FM Out (optional) Antenna Input

Option 1: Windshield Mount

•Do not install Here2Everywhere on the windshield if it may obstruct your view while driving.

•Attach the Car Docking Cradle to the Car Windshield Docking Base using the four enclosed screws.

•Loosen the base nut on the Car Windshield Docking Base so that the suction cup portion rotates easily. Do not remove the base nut entirely.

•Make sure the suction cup lever is in the up position.

• Position the suction cup base on the desired windshield location. The word “PRESS” should be upright.

•Press the button marked “PRESS” while the suction

cup is on the windshield.
Then rotate the lever
down, keeping the button
pressed down at the
same time.
• The suction cup base	7
should be firmly
attached to the
windshield.

Note: To remove the Car Windshield Docking Base, return the lever to the up position before attempting to remove the Base.

Option 2: Console

(Professional) Mount

Ask the dealer where you purchased your

Here2Everywhere about professional installation options. One option is to have the dealer mount the Pivot of the Car Windshield Docking Base to the console or other available location in the vehicle. There are four screws to remove. The Pivot screw holes match the AMPS standard for mounting systems, so any AMPS-compatible bracket for your vehicle will accept the Pivot of the Docking Base. Many car audio dealers carry these brackets.

If you choose to do the console mount yourself, please observe the following guidelines: