Kenwood HES20 Clearance to Combustibles, Hearth, Plexiglass Information, Electric Specifications

Clearance to Combustibles

Back . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2” (51 mm) Sides . . . . . . . . . . . . . . . . . . . . . . . . . . . .6” (153 mm) Floor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0” (0 mm) Top . . . . . . . . . . . . . . . . . . . . . . . . . . . .24” (610 mm)

Hearth

A hearth is not mandatory, but is recommended for aesthetic purposes. We recommend a noncombustible hearth which does not obstruct heater openings.

Plexiglass Information

1.This product uses plexiglass on the door window.

2.Under no circumstances should this product be operated with missing or broken plexiglass.

3.Do not strike or slam the plexiglass.

4.Do not use abrasive cleaners to clean the plexi- glass.

Electric Specifications

Voltage . . . . . . . . . . . . . . . . . . . . . . . .120V AC/60Hz

Total Amps . . . . . . . . . . . . . . . . . . . . . . .12.20 Amps

Total Watts . . . . . . . . . . . . . . . . . . . . . . . .1460 Watts

Heater Ratings . . . . . . . . . . . . . . . . . . . .1300 Watts

Electrical Connection

A 15 Amp, 120 Volt, 60 Hz circuit with a properly grounded outlet is required. Preferably, the appliance will be on a dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in operation.

The unit comes standard with a 6’ (1.8m) long three wire cord, exiting from the rear of the stove. Plan the installation to avoid the use of an extension cord. If an extension cord must be used, it must be a minimum 14AWG, three wire with grounding type plug connector and rated not less than 1875 Watts. The cord shall not be more than 20’ (6m) in length.

WARNING: Electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electrical shock and injury to persons.

WARNING: Do not use this stove if any part of it has been under water. Immediately call a qualified service tech- nician to inspect the stove and replace any part of the electrical system.

Grounding Instructions

This heater is for use on 120 volts. The cord has a plug as shown at A in Figure 1. An adapter as shown at C is available for connecting three-blade grounding- type plugs to two-slot receptacles. The green ground- ing lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box. The adapter should not be used if a three- slot grounded receptacle is available.

A

		Cover of
Grounding Pin		Grounded
	B	Outlet Box

C

Metal Screw

Adapter

Grounding Means

Fig. 1 Grounding methods.

10005632 5