Kenwood KAC-5204 Controls / Indicator, 1Speaker level input terminals, 2LINE IN terminal, 3INPUT SENSITIVITY control, 4FILTER switch, •OFF position:, 5Fuse (25 A)

Controls / Indicator

FUSE [25A]	BATT. P.CON GND				BRIDGED	SPEAKER OUTPUT
			LEFT			RIGHT
	POWER IN
	  				
									40 3020
									10
	SPEAKER LEVEL INPUT	LINE IN							(W)
					0.5	FILTER			0.5
			1		0.3		1		0.3
			2
			34	5	0.2 [MAX]	OFF LPF	2
			[MIN]
	L		R		INPUT		3
			SENSITIVITY[V]				4	5	0.2 [MAX]
							[MIN]
									INPUT
							SENSITIVITY[V]
					 

1Speaker level input terminals

NOTE

•The genuine-accessory car stereo shall have a maximum power output of no more than 40 W.

•Do not connect the speaker output leads from a power amplifier (Optional) to the speaker level input terminals of this unit, for this may cause malfunction or damage.

•Do not connect cables and leads to both RCA cable input jacks and the speaker level input terminals simultaneously, for this may cause malfunction or damage.

•Connect the power control lead to a power supply which can be turned ON/OFF by the ignition key switch (ACC line). With this connection, shock noise may be generated when the power of the genuine-accessory car stereo is switched ON/OFF.

2LINE IN terminal

3INPUT SENSITIVITY control

Set this control according to the pre-output level of the center unit connected with this unit, or to the maximum power output of the genuine- accessory car stereo.

Use the diagram on the right as a guide.

NOTE

For the pre-output level or the maximum power output, refer to the <Specifications> in the instruction manual of the center unit.

4FILTER switch

This switch allow filtering of the speaker output signals.

•OFF position:

The original sound without filtering is output.

•LPF (Low Pass Filter) position:

Only frequencies of 80 Hz or lower are output. (Frequencies above 80 Hz are cut.)

The speaker output is automatically switched to monaural (L+R).

5Fuse (25 A)

6Battery terminal

7Power control terminal

Controls the unit ON/OFF.

NOTE

Controls the unit power. Be sure to connect it with all the systems.

8Ground terminal

9Speaker output terminals

•Stereo Connections:

When you wish to use the unit as a stereo amplifier, stereo connections are used.

The speakers to be connected should have an impedance of 2Ω or greater. When multiple speakers are to be connected, ensure that the combined impedance is 2Ω or greater for each channel.

•Bridged Connections:

When you wish to use the unit as a high- output monaural amplifier, bridged

connections are used. (Make connections to the LEFT channel 9 and the RIGHT channel · SPEAKER OUTPUT terminals.)

The speakers to be connected should have an impedance of 4Ω or greater. When multiple speakers are to be connected, ensure that the combined impedance is 4Ω or greater.

English