Kenwood KAC-816 2WARNINGNOTE, Power terminal, Speaker output cable terminal, ■Power and Speakers cable connection

■Power and Speakers cable connection

Power control cable

FUSE(20A)	POWER IN
20	BATT GND

FUSE(20A)

Terminal cover

Battery cable (Yellow)

Subwoofer

Distribute the speaker cables and sigma servo cables along the same paths.

∑SERVO ΙΙ∑ SERVO ΙΙ

P.CON(REMOTE)

Power control (REMOTE) lead terminal

Ground cable (Black)

•If a buzzing noise is heard from the speakers when the engine is running, connect a line noise filter (optional) to each of the battery cable.

•Do not allow the cord to directly contact the edge of the iron plate by using Grommets.

Fire wall

Grommets

Battery

Round terminal (Large)

2WARNINGNOTE

To prevent fire caused by a short in the wiring, connect a fusible link or breaker nearby the battery’s positive terminal.

•Connect the ground cable to a metal part of the car chassis that acts as an electrical ground passing electricity to the battery‘s negative - terminal. Do not turn the power on if the ground cable is not connected.

•When installing two amplifiers, connect a power tune-up cable to each of them while taking care not to exceed the cable capacity.

•The power cable should be thick enough to supply the required current and connected directly from the battery.

Speaker output cable terminal

Connect the speaker output cables to these terminals.

Power terminal

Pass battery and ground cables through supplied terminal cover and connect to respective terminals. After completing connections, fasten terminal cover over terminal bracket.

	Lead terminal	Round terminal (Medium)
	Lead terminal	Round terminal (Small)
	(Commercially	Round terminal (Small)
	available part)
	Speaker output
	cable